Dana 60 Front Differential Oil Selection & Service Intervals. Ford calls for an
SAE 80W-90 gear oil
in its Ford Super Duties equipped with the Dana 60 front differential.
What type of oil goes in a differential?
There are two types of differential fluid. One is
mineral oil
, which is a natural, crude oil-based fluid. The other is synthetic differential fluid, which is created in a lab. As with all synthetic oils, synthetic differential fluid oils can be fine-tuned for optimal performance.
How much gear oil does a Dana 60 hold?
3 quarts
is about right.
Is a Dana 60 a 1 ton axle?
One thing that’s confusing about the Dana 60 axles is that
a Dana 60 in front is usually considered a 1 ton axle
, and a Dana 60 in the rear is usually considered a 3/4 ton axle. … This is most likely because the rear axle in a truck carries more weight than the front (when loaded).
What is the best oil for differential?
- Red Line MT-90 — Best Differential Fluid.
- Lucas Oil 10048 — Great for Synthetic Transmission and Differential.
- Red Line 75W90 — Gear Oil for Faster Shifting.
- Honda 08200-9003 — VTM-4 Differential Fluid.
- Mobil Delvac Syn Gear 75W90 — Fully Synthetic Differential Fluid.
- Royal Purple ROY01300 — High-Quality Synthetic Lube.
What is a Dana 60 front axle?
The Dana/Spicer Model 60 is
an automotive axle manufactured
by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. … Gross axle weight ratings are often lowered by the vehicle manufacturer for safety and tire reasons.
Is differential oil the same as gear oil?
Every front or rear axle is filled with a special oil (also called
differential
fluid, or gear oil) that takes care of this. The differential fluid lubricates the gears, bearings and other internal parts, and provides cooling to these components as well.
What oil goes in the gearbox?
Synthetic gear oil
is chemical-based gearbox oil made up of polyalphaolefins (PAO), esters oils or polyglycols. Synthetic gear oils are multigrade and have every preventive additive included as part of its makeup. This gearbox oil can be run at extremely high or low temperatures.
How do I choose a diff oil?
The diff oils have a significant impact on your car’s performance. The basic set up we recommend is
5000 cSt in the front, 5000 cSt in the center and 3000 cSt in the rear
. With this setup, you’ll achieve neutral behavior while cornering and during acceleration when exiting corners.
How much horsepower can a Dana 60 handle?
The 23-spline axle from our 1968-vintage Dana 60 is 1/4-inch thicker in the spline area. The beefier Dana 60 axles and diff can handle up to 200 more horsepower than the 8 3/4, but not
more than about 650 hp with slicks
at the strip.
What gear ratio is a Dana 60?
The Dana 60 carrier split is at
4.56:1-and-up
ratio gears.
What is a high pinion Dana 60?
A high-pinion Dana 60 front axle is
one of the top upgrades for truck and SUV wheelers across the board
. The 9.75-inch ring gear provides plenty of beef for running 39-inch and larger tires, and since it is a high-pinion front, the pinion churns on the stronger drive-side of the ring gear.
Which is better 75W90 or 80W90?
Ans:
75W90 is artificial
and mostly better than 80W90, but it costs more. 75W90 has a better low-temperature viscosity and is good to run all over. If you’re in a warmer zone, using 75w90 will be more suitable than 80w90 for you.
Is it OK to use 75W90 instead of 75w85?
Our answer: Yes,
75W-85 gear
oil can most definitely be replaced by 75W-90.
Can I use 75W140 instead of 75W90?
Can I use 75w140 instead of 80w90?
Either one is fine
. Generally the synthetic 75w-140 is for HD applications such as towing, but it will work fine in any application.
