Pass with a distance between the motor vehicle and the bicycle of
not less than three (3) feet
. When overtaking a bicycle, pass safely at a distance of not less than 3 feet.
What should you do when approaching a bicyclist?
- Allow them at least 3 feet of space.
- Do not force them into parked vehicles or off the road.
- Pass a bicyclist at a safe speed.
- If there is an oncoming vehicle approaching and you need to pass a bicycle, wait until the vehicle has passed before passing the bike.
Which is true when passing a bicycle rider?
Do not pass a cyclist just before making a right turn
. Merge first, and then turn. Before passing a cyclist in a narrow traffic lane, wait until the traffic is clear in the opposite lane, and then change lanes to pass the cyclist. Do not attempt to squeeze past the cyclist.
When a traffic lane is too narrow for a bicyclist and motorist to travel safely side by side a motorist should do which of the following?
n Motorists must maintain at least three feet of clearance when passing a bicyclist. n When a road is too narrow for cars and bikes to ride safely side by side,
bicycles
should take the travel lane, which means riding in or near the center of the lane. n Bicyclists must obey all traffic controls, signs and signals.
What should you do when approaching or passing a bicyclist quizlet?
Three feet
is the minimum passing space that motorists should leave when passing a bicyclist. Higher speeds require more passing space. Always wait until you can see oncoming traffic and then safely pass by moving partially or fully into the other lane. This delay is usually brief.
When should you ride a bike?
- Go With the Traffic Flow. Ride on the right in the same direction as other vehicles. …
- Obey All Traffic Laws. A bicycle is a vehicle and you’re a driver. …
- Yield to Traffic When Appropriate. …
- Be Predictable. …
- Stay Alert at All Times. …
- Look Before Turning. …
- Watch for Parked Cars.
What should you be looking for when approaching an intersection?
Before you enter an intersection,
look to both the left and right for approaching
vehicles or crossing pedestrians. Look to your left a second time, as vehicle approaching from your left will be closer than those approaching from your right.
When approaching a vehicle in a parking lot you should always approach from?
When approaching your vehicle parked at a curb, you should:
Approach the driver’s door from the front of your vehicle, facing oncoming traffic
.
How much distance should you leave for a bicycle?
The recommended distance when passing a cyclist is
1.5m
.
If you are passing a cyclist who is riding next to a line of parked cars, they will need to ride further out into the lane to protect themselves against people opening car doors. When you are following a cyclist and are about to overtake, look at the road ahead.
When motorists are turning right and a bicyclist is approaching on the right they should let the cyclist go through the intersection first before making a right turn?
Explanation If you are turning right and a bicyclist is approaching on the right, you should let the bicyclist go through the intersection before making your turn.
What drivers should know about bicyclist?
Know Bicyclists’ Rights: Drivers sometimes have little idea of the traffic laws that apply to bicyclists. … NHTSA says cyclists
10 years and older should behave as though they were vehicles on the street
, riding in the same direction as other traffic that’s going their way and following the same traffic rules.
When approaching a bicyclist from the rear you should slow down and?
When approaching a bicyclist from the rear, you should slow down and:
Wait until it is safe to pass the bicyclist with at least three feet of clearance
. A green arrow showing at the same time as the red traffic light means: You may go in the direction of the arrow with caution.
Where are bicycles supposed to ride?
When riding on the road, bicycles are required to travel in the same direction as the flow of traffic. For those of us living in the United States, this means always
riding on the right side
as well as utilizing the right side of the lane as much as possible unless it is unsafe to do so.
When approaching an intersection with a bicyclist the motorist yields the right of way?
When riding straight across an intersection, a biker has the right of way
as soon as the light turns green
. If the car to his left wishes to turn right, the vehicle must wait for the bike to pass before attempting the turn, just as he would have to wait for a pedestrian in the crosswalk.
When can you enter a bike lane quizlet?
When can you drive in a bicycle lane? When you
are making a right turn and are within 200 feet
of the corner or other driveway entrance, you must enter the bicycle lane only after ensuring there is no bicycle traffic, and then make the turn. Do not drive in the bicycle lane at any other time.
When approaching an intersection preparing for a left turn what should you do?
- Turn on the left turn signal before you make the turn and slow down.
- Look both ways and make sure that the oncoming lanes are clear.
- Make the turn from the designated lane (use left lane).
- Do not enter into the right lane. In some states, it is illegal to enter the right lane after the turn is completed.
What should you do when you approach the top of a hill?
Maintain a steady speed
. You may not know what is on the other side of a hill or just around a curve, even if you have driven the road many times. If a vehicle is stalled just out of sight on the roadway, you must be able to stop. Whenever you come to a hill or curve, adjust your speed so you can stop if necessary.
How can I promote my bike safety?
Be a sponsor for a
bicycle helmet giveaway program
. Provide financial support for bicycle 41. safety equipment giveaways including helmets, retro-reflective gear, or bicycle lights. Educate adults about the importance of being a good role model; encourage them to set the 42.
Which of the following hazards may cause a bicyclist to move into the middle of the lane?
Hazards that could cause problems for a bicyclist include
potholes, glass, litter, storm grates and railroad crossings
, as well as opened doors of parked vehicles. Any of these items could cause a bike rider to move into your path or to slow down.
What are the bicycle signals?
Bicycle hand signals are part of California law for bicycling. The three signals are
left arm extended straight out to the left side (for a left turn), left arm extended and bent upward at a 90-degree angle (for a right turn), and left arm extended and bent down at a 90-degree angle (for braking)
.
What are the safety rules for riding a bike?
- Ride What You Can Handle. Do not buy a two-wheeler based on its appearance. …
- Invest in a Helmet. …
- Rider Have to be Visible. …
- Wear Safety Gear. …
- Do not Ride under Bad Weather Conditions. …
- Check Your Bike Before You Ride. …
- Obey Rules. …
- Buy Two Wheeler Insurance.
When approaching an intersection What 5 things do you search for?
Inspect the intersection. Look for
stoplights, stop signs, turning lights and restrictions, one way signs, road blocks or construction, pedestrians and crosswalks, and bike lanes
. Be aware of anything that could potentially create a collision.
When approaching an intersection which response best describes the scanning method or sequence you should use to identify hazards before entering?
Before entering or leaving an intersection, scan left, centre, right and left again.
Reduce your speed as required
. Check your rear view mirror, shoulder check and signal.
When approaching an intersection for a left turn you should approach the intersection?
If a driver traveling straight approaches an intersection where another driver is already making a left turn,
they must let that vehicle complete its turn before entering the intersection
. Drivers entering a traffic circle or rotary must yield to drivers already in the circle.
What is the first step when approaching your parked car before?
While approaching your car, the first step before getting in should be?
Release some braking pressure 1-2 seconds before the car stops
.
When approaching a vehicle with a trailer you should?
It is best to avoid backing if possible, but sometimes backing is necessary, so drivers should learn to do it. There are two different ways to back a trailer. trailer and towing vehicle,
stop
, pull ahead to straighten out; then begin again. Once you start to go correctly, follow the trailer around.
Why are bicycle riders encouraged to carry ID on them when riding?
“The next 12 months is about getting cyclists used to carrying ID, primarily to ensure
family members
can be notified if there is a crash and to help emergency services staff provide the best medical support they can. “We encourage cyclist to carry driver licences, passports or Service NSW issued ID cards.
When turning left and there is a bicyclist entering the intersection from the opposite direction you should wait for the bicyclist to pass before making the turn?
A motorist making a left turn at an intersection
must yield the right-of-way to a bicyclist
entering the intersection from the opposite direction. Explanation When turning left at an intersection, you must yield to oncoming bicycles in the same manner that you would yield to oncoming motor vehicles.
When a bicyclist is on the sidewalk a driver should group of answer choices?
In turning right (or left on a one-way street), the driver should check the blindspot and the side mirror to make sure the vehicle is not turning into the path of a cyclist going straight. In turning left, the driver should
look not only for oncoming vehicles
but also for bicycles riding on the sidewalk.
What is the safest way to approach your vehicle?
When parked at a curb, which direction should you approach to enter the vehicle?
Always approach from the front
. When turning your last check is: In the direction of your intended path of travel.
Who do you give way to when merging?
When merging into another lane, you must give
way to anyone that’s in the lane you’re moving into
and it’s important that you indicate for a reasonable amount of time to warn other people that you intend to cross into their lane.
What should you do when turning while backing?
Always go slowly, watching carefully in all directions. To steer the car in reverse, turn the wheel in the direction you want the rear of the car to go.
Turning the wheel to the right steers the back of the car to the right
. Turning the wheel to the left steers to the left.
How should you ride when riding in a group?
- Be Prepared Before Going to the Ride. …
- Know Hand Signals. …
- Hold a Pre-Ride Meeting. …
- Select a Group Lead and Sweep. …
- Keep Your Group’s Size Manageable. …
- Stagger Your Riding Formation. …
- Stay Aware of Your Group’s Riders While on the Road.
Can a 12 year old ride a bike on the road?
The law states that
the pillion riders must be aged 12 years or above to ride on a two-wheeler
, meaning that children under that age cannot legally ride alongside their parents, said Dadapeer, a surveillance technician at Bangalore’s Traffic and Transit Management Centre (TMC).
When you see cyclists ahead you should?
When you see a cyclist up ahead in the road,
remember to slow down
! Passing riders at high speeds increases the chance of an accident, and can be terrifying to the riders. Wait until you are on a clear, straight stretch of road so you can safely pass. Passing on hills can also be dangerous because it limits visibility.
When should you follow a bike?
Pass with
not less than three (3) feet
and maintain such clearance until safely past the overtaken bicycle. Pass with a distance between the motor vehicle and the bicycle of not less than three (3) feet. When overtaking a bicycle, pass safely at a distance of not less than 3 feet.
Why is bicycle safety important?
Why Is Bike Safety So Important? Bike riding is a lot of fun, but
accidents happen
. The safest way to use your bike is to get places, not to play. Every year, lots of kids need to see their doctor or go to the emergency room because of bike injuries.
What should you do when approaching a bicyclist?
- Allow them at least 3 feet of space.
- Do not force them into parked vehicles or off the road.
- Pass a bicyclist at a safe speed.
- If there is an oncoming vehicle approaching and you need to pass a bicycle, wait until the vehicle has passed before passing the bike.
When approaching and driving through a construction zone you should?
When approaching and driving through a construction zone you should:
Slow your speed and adjust your vehicle’s position
.
When approaching a vehicle in a parking lot you should always approach from?
When approaching your vehicle parked at a curb, you should:
Approach the driver’s door from the front of your vehicle, facing oncoming traffic
.
