- Allow them at least 3 feet of space.
- Do not force them into parked vehicles or off the road.
- Pass a bicyclist at a safe speed.
- If there is an oncoming vehicle approaching and you need to pass a bicycle, wait until the vehicle has passed before passing the bike.
When you see cyclists ahead you should?
When you see a cyclist up ahead in the road,
remember to slow down
! Passing riders at high speeds increases the chance of an accident, and can be terrifying to the riders. Wait until you are on a clear, straight stretch of road so you can safely pass. Passing on hills can also be dangerous because it limits visibility.
What might you expect to happen if a bicycle rider is a child?
Expect the child
to be in total control of the bicycle
. … Explanation Children on bicycles are sometimes unpredictable. Young bicyclists are especially likely to make surprising changes in direction. Remember that children and bicycles are both small in stature and may become difficult to see.
What action should you take when passing a bicyclist ahead of you?
When you pass a bicyclist,
slow down and pass the bicyclist only when safe
, allowing for a minimum of 3 feet between your vehicle and the bicyclist where possible. Do not squeeze the bicyclist off the road.
What should you do when approaching or passing a bicyclist quizlet?
Three feet
is the minimum passing space that motorists should leave when passing a bicyclist. Higher speeds require more passing space. Always wait until you can see oncoming traffic and then safely pass by moving partially or fully into the other lane. This delay is usually brief.
When should you ride a bike?
- Go With the Traffic Flow. Ride on the right in the same direction as other vehicles. …
- Obey All Traffic Laws. A bicycle is a vehicle and you’re a driver. …
- Yield to Traffic When Appropriate. …
- Be Predictable. …
- Stay Alert at All Times. …
- Look Before Turning. …
- Watch for Parked Cars.
When motorists are turning right and a bicyclist is approaching on the right they should let the cyclist go through the intersection first before making a right turn?
Explanation If you are turning right and a bicyclist is approaching on the right, you should let the bicyclist go through the intersection before making your turn.
When approaching a vehicle in a parking lot you should always approach from?
When approaching your vehicle parked at a curb, you should:
Approach the driver’s door from the front of your vehicle, facing oncoming traffic
.
When approaching a bicyclist from the rear you should slow down and?
When approaching a bicyclist from the rear, you should slow down and:
Wait until it is safe to pass the bicyclist with at least three feet of clearance
. A green arrow showing at the same time as the red traffic light means: You may go in the direction of the arrow with caution.
What might you expect to happen if the bicycle rider is a child quizlet?
Expect
anything could happen and adjust your driving
. If the bicycle rider near you is a child: Slow your speed and adjust your vehicle’s position.
What should you do when a motorcycle is following your vehicle?
To protect a tailgating motorcyclist while following another vehicle,
you should increase your following distance
. When a motorcycle is overtaking you, you should maintain speed and lane position.
What action should you take when approaching a railroad crossing quizlet?
Terms in this set (5) Railroad crossings are always dangerous.
Drivers should listen and look both ways for an approaching train, and for signals indicating an approaching train
. Never proceed until you are certain it is safe to do so.
What should you do if you are approaching a school bus that has flashing red lights?
You must stop when you approach
a school bus with flashing red lights activated and stop arm extended. If you are driving on a highway that is divided by a barrier or unimproved median, you are required to stop only if you are traveling in the same direction as the school bus.
What are the laws and actions associated with approaching a bicyclist?
The
law requires the motorist to yield to the cyclist going straight if there is any chance of collision
. The few seconds a motorist may save in rushing a turn may cost a bicyclist’s life. … In turning left, the driver should look not only for oncoming vehicles but also for bicycles riding on the sidewalk.
What are 2 of the steps a bicyclist must take when on the roadway?
- Slow Down.
- Look and Wait until Safe.
- Change Lanes to Pass. Let’s look at each step in detail:
- Slow Down. …
- Look and Wait until Safe. …
- Change Lanes to Pass.
When approaching an intersection with a bicyclist the motorist yields the right of way?
When riding straight across an intersection, a biker has the right of way
as soon as the light turns green
. If the car to his left wishes to turn right, the vehicle must wait for the bike to pass before attempting the turn, just as he would have to wait for a pedestrian in the crosswalk.
When approaching an intersection preparing for a left turn what should you do?
- Turn on the left turn signal before you make the turn and slow down.
- Look both ways and make sure that the oncoming lanes are clear.
- Make the turn from the designated lane (use left lane).
- Do not enter into the right lane. In some states, it is illegal to enter the right lane after the turn is completed.
What are the bicycle signals?
Bicycle hand signals are part of California law for bicycling. The three signals are
left arm extended straight out to the left side (for a left turn), left arm extended and bent upward at a 90-degree angle (for a right turn), and left arm extended and bent down at a 90-degree angle (for braking)
.
When riding a bicycle you should ride in the same direction as other traffic True or False *?
As bicycles are considered vehicles, bicyclists on public streets have the same rights and responsibilities as automobile drivers. They should ride in
the same direction as other traffic
.
What are the rules for cyclists?
- RULE: YIELD TO PEDESTRIANS OR OTHER VEHICLES ALREADY ON THE ROADWAY. …
- RULE: RIDE IN THE SAME DIRECTION AS THE FLOW OF TRAFFIC. …
- RULE: DON’T RIDE ON THE SIDEWALK. …
- RULE: OBEY ALL TRAFFIC SIGNALS AND SIGNS.
What are the safety rules for riding a bike?
- Ride What You Can Handle. Do not buy a two-wheeler based on its appearance. …
- Invest in a Helmet. …
- Rider Have to be Visible. …
- Wear Safety Gear. …
- Do not Ride under Bad Weather Conditions. …
- Check Your Bike Before You Ride. …
- Obey Rules. …
- Buy Two Wheeler Insurance.
When turning left and there is a bicyclist entering the intersection from the opposite direction you should wait for the bicyclist to pass before making the turn?
A motorist making a left turn at an intersection
must yield the right-of-way to a bicyclist
entering the intersection from the opposite direction. Explanation When turning left at an intersection, you must yield to oncoming bicycles in the same manner that you would yield to oncoming motor vehicles.
What should you do when turning while backing?
Always go slowly, watching carefully in all directions. To steer the car in reverse, turn the wheel in the direction you want the rear of the car to go.
Turning the wheel to the right steers the back of the car to the right
. Turning the wheel to the left steers to the left.
When opening your driver’s side door in a road with oncoming vehicle and bicycle traffic you should * 1 Point?
When opening your driver’s side door in a road with oncoming vehicle and bicycle traffic, you should: a.
Open the vehicle door by reaching across with your right hand
to get a better view of the vehicle and bicycle traffic approaching from behind.
When approaching your vehicle before getting in you should?
When approaching your vehicle before an inspection, make note of its general condition and ensure that it is not damaged or leaning.
Look under the vehicle for fresh leaks
. Check around the vehicle for hazards to movement, such as people, other vehicles, or low-hanging wires or tree limbs.
What is the first step when approaching your parked car before?
While approaching your car, the first step before getting in should be?
Release some braking pressure 1-2 seconds before the car stops
.
When approaching and driving through a construction zone you should?
When approaching and driving through a construction zone you should:
Slow your speed and adjust your vehicle’s position
.
When you see cyclists ahead you should?
When you see a cyclist up ahead in the road,
remember to slow down
! Passing riders at high speeds increases the chance of an accident, and can be terrifying to the riders. Wait until you are on a clear, straight stretch of road so you can safely pass. Passing on hills can also be dangerous because it limits visibility.
What should you do when approaching or passing a bicyclist quizlet?
Three feet
is the minimum passing space that motorists should leave when passing a bicyclist. Higher speeds require more passing space. Always wait until you can see oncoming traffic and then safely pass by moving partially or fully into the other lane. This delay is usually brief.
When approaching a vehicle with a trailer you should?
It is best to avoid backing if possible, but sometimes backing is necessary, so drivers should learn to do it. There are two different ways to back a trailer. trailer and towing vehicle,
stop
, pull ahead to straighten out; then begin again. Once you start to go correctly, follow the trailer around.
What should you do when approaching a bicyclist?
- Allow them at least 3 feet of space.
- Do not force them into parked vehicles or off the road.
- Pass a bicyclist at a safe speed.
- If there is an oncoming vehicle approaching and you need to pass a bicycle, wait until the vehicle has passed before passing the bike.
How should you use the IPDE process when planning an exit from an expressway?
How can you apply the IPDE process to exit an expressway? Execute your maneuver smoothly and blend with slower traffic. What steps should you take when exiting an expressway? *
At least 1/2 mile from exit signal and make lane change to position 3
when safe to do so.
When deciding whether to pass a vehicle ahead of you what is the most important factor to consider?
when deciding whether to pass a vehicle ahead of you, the most important factor to consider is…
the space and time needed to pass
. before changing lanes, the most important thing you should do is: make sure the area and travel path are open.
What should you do when approaching a school bus?
You
must stop your vehicle at least 20 feet before reaching a school bus
that is stopped with its red lights flashing whether it is on your side of the road, the opposite side of the road, or at an intersection you are approaching. You must remain stopped until the flashing red lights are no longer operating.
When should I stop approaching school?
According to California law,
drivers must stop when a school bus stops in front of them and extends its stop sign with flashing lights
. In California, the fine for passing a school bus can be up to $600, according to the California Highway Patrol.
What must you do when approaching a school bus that has its lights flashing and its stop arm extended?
Explanation When a school bus stops with its lights flashing and its stop arm extended, you
must stop at least 10 feet away from the bus
. Remain stopped until the red lights stop flashing, the stop arm has been withdrawn, and the children have reached a safe place.
What difference between a vehicle and a bicycle place the bicyclist at a major disadvantage in any collision?
What differences between a vehicle and a bicycle place the bicyclist at a major disadvantage in any collision? …
they do not accelerate as quickly as a vehicle or motorcycle
. During rain or snow, you should predict that pedestrians will. pay little attention to traffic.
When approaching the top of a hill passing is not allowed when?
When approaching the top of a hill, passing is not allowed
within 700-1000ft before
.
What action should you take when approaching a railroad crossing?
Explanation When approaching an unmarked railroad crossing,
slow down and be prepared to stop
. Before you cross, be sure that no trains are approaching from either direction on any track. If you see or hear a train coming, stop at a safe distance from the nearest track and wait to proceed until after the train passes.
What should you do when approaching a railroad?
When you see any signs indicating a nearby railroad crossing, you
should slow down, look for a train, and be ready to stop
. If the red warning lights are flashing or the gate is down, you must stop 15 to 50 feet before the railroad tracks. Do not try to go around the gate.
