14, 15, & 16MM
are all common sizes for that. And the starter bolts are usually 2 sizes also.. being 14 and 15MM.. usually a 14, though.
What is a starter bolt?
Installing starter motors in the cramped confines of a race car is simplified by use of ARP’s special bolts, which feature small diameter heads to make accessibility more convenient. They are stronger than OEM and industrial grades, and especially suited for use on cars that use rear motor plates.
What tools are needed to replace a starter?
- Sockets and wrenches.
- Screwdriver.
- Pliers.
- Battery terminal puller.
- Drive-on ramps, jack or jackstands.
Where are the bolts on a starter?
Usually the bolts are on
the back side of the starter
and, while they can often be seen from the front, can only be accessed from the rear. In order to reach them, one must first climb underneath the car.
What size are LS starter bolts?
11610633 – Replacement GM Starter Bolt – Fits Most OEM LS Starters, LS1. LS2, LS6, LS3, LQ4, LQ9 Etc –
10mm X 1.5 X 120mm
.
Can you replace starter yourself?
You
can buy a new starter
, which is rather expensive, or you can buy a rebuilt starter, which is just as good as a new one [source: Allen]. If the problem is really your starter, save yourself a trip to the mechanic and replace it yourself. … Disconnect all the bolts that hold the starter to the block, using a ratchet.
Is replacing a starter easy?
Replacing a car’s starter motor isn’t difficult. However, vehicles with large engines will be more challenging. Front wheel drive transverse powertrain layout is the most common type and generally offers a better access to the starter motor, and is therefore
easiest to replace
.
Can you jump a car with a bad starter?
Jump-starting a car with a bad starter motor
will not help start the engine
. Jump-starting will only boost battery power. A manual transmission car with a bad starter maybe push or tow started but an auto transmission car can not.
What causes broken starter bolts?
missing bracket
is usually the cause for broken starter bolts.
How do I check my starter clearance?
See all 8 photos The easiest way to check for proper starter engagement is with a small wire or even a paper clip. With the starter’s pinion gear pulled out, measure the backlash between it and the ring gear. Ideal clearance is anywhere
between 0.020 and 0.030 inch
. IMI uses a modified spark plug gapper for this check.
How much can I shim a starter?
If you need much more than
. 10′′ of shims
, the nosecone casting is improperly machined. The more shims you install, the more chance you run of the the starter “rocking” while turning the engine and bending your bolts or cracking the bolt holes in the block (even with the front brace installed).
How do I know if my starter is bad?
- Something sounds off. …
- You’ve got lights but no action. …
- Your engine won’t crank. …
- Smoke is coming from your car. …
- Oil has soaked the starter. …
- Look under the hood. …
- Tap the starter. …
- Adjust the transmission.
