The axle nut size for a subaru legacy is
32mm
with a thread size of m22-1.50.
What size is the axle nut on a Subaru Outback?
Generally it’s
32mm
. There is some other size people have encountered but I forget what it is…… If you’re planning to loosen it, at least 3/4′′ drive stuff is recommended…. 1/2′′ drive has been broken on this job…..
What size is the axle nut socket?
This
36mm
axle nut socket is extra deep to fit various axle lengths and can be used to remove or install axle nuts on front wheel drive vehicles.
What size is the axle nut on a 2014 Subaru Forester?
Axle Nut Length
(mm): 34.4
.
What are the most common axle nut sizes?
| Item No. Description Weight | 30410 3.25′′ 8 pt. Axle Nut Socket 2.7 lbs (1.2 kg) | 30411 3.5′′ 6 pt. Axle Nut Socket 2.95 lbs (1.3 kg) | 30412 3.75′′ 8 pt. Axle Nut Socket 3.15 lbs (1.4 kg) | 30413 4′′ 6 pt. Axle Nut Socket 3.35 lbs (1.5 kg) |
|---|
What size is Honda axle nut?
The nut part should be
36mm in diameter
. The part # 90305-S30-003 should be a 32mm size.
What size socket do I need to remove a wheel bearing?
It’s a
4 MM
!
What is the most common spindle nut?
There are several manufacturers offering one-piece spindle nut systems. The two most common are
the Axilok® nut by Metform
(see Figure 1) and the PRO- TORQ® nut by Stemco (see Figure 2). Each of these systems has a specific installation procedure required by the manufacturer to set wheel bearing end-play.
How do you measure axle nut size?
Stretch the tape measure across the nut’s diameter
to the flat-side directly across from the one your pulling from. If the nut is metric, count the number of lines on the tape measure to find the measurement. If you count 9 lines, the size is a 9-mm (millimeter) nut.
What size is the axle nut on a 99 Honda CRV?
Dorman AutoGrade
M24-1.50
Thread Axle/Spindle Nut.
Do you have to replace axle nut?
I’m referring to the special nuts on major components like axle shafts and ball joints where a lost (or loosened) nut can cause accidents, even fatal accidents. … Whichever style is on your vehicle,
make sure you buy a new nut after removing the old one
. The old nut will not hold the proper torque a second time.
How tight should my axle nut be?
The nut on the spindle should be tightened
until snug
, with no side-to-side play in the hub and then backed off, about a quarter of a turn. The nut finger should be tight until the castle nut or cotter pin is used.
Can you over tighten an axle nut?
It’s possible to damage the wheel, rotor, and hub assembly. The wheel can come off if over-torquing the nuts/bolts is done. It happens, but it doesn’t happen a lot. The only way to tighten them is
with a Torque wrench
.
What is the torque for axle nut?
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200 ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of
300 ft-lbs.
