What Size Is The Oil Drain Bolt? - Fixanswer

Place a

3/8-inch (0.9 centimeters)

socket in the socket wrench, fit it over the drain plug's nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine. Make sure to place a bucket and some newspaper under the car's engine to catch all the draining oil.

Are all oil drain plugs the same size?

All drain pans are not designed the same which

is why different drain plugs are required for different vehicles. … There is as much engineering going into the oil drain plug as any other part or system on the vehicle. Some vehicles have a reinforced drain plug hole and others do not.

What size wrench Do I need to remove the oil drain plug?

GearWrench

16mm

Magnetic Drain Plug Socket 3/8 Inch Drive 6 Point.

How often should you change your oil drain plug?

Your drain plug should last the life of your engine if it is properly Torqued

every time

during oil change. I haven't stripped a single drain plug in 20 years.

What do I do if my oil pan plug is stripped?

Be sure that you order a new drain plug for your car before removing the stripped one. …
Use a pair of round-jaw vice grip pliers. …
Turn your pliers counterclockwise – to the left. …
Finally, you'll feel the drain plug begin to loosen.

What kind of wrench do I need to change oil?

1.Wrench. The most common tool used when changing motor oil is

the combination wrench

. This kind of wrench has both an open side and a closed side. The open end can be used to remove the wrench and position it on the nut.

What tool do I need to change oil?

In addition to oil, you'll need an oil filter, an

oil-filter removal wrench

, a wrench to remove the drain plug, a funnel, a drain pan and some gloves. You may also need to raise the car to gain access, in which case you'll need a floor jack and safety stands, or a pair of purpose-made steel ramps.

Do I really need an oil filter wrench?

Every reputable oil filter is designed to seal for tens of thousands of miles with no more than a good hand-tightening.

You don't need a wrench unless

you have one of those deeply recessed filters with no space around it for your hands. … Then use the wrench to tighten a half-turn more.

How much should you torque oil drain plug?

20 to 25 foot-pounds

is the Torque specification for oil drain plugs.

How long do you let oil drain?

The oil will warm up to about 100 degrees, which is not hot enough to burn you, but warm enough that it will flow easily. If the vehicle has been driven, let it sit for

20-30 minutes

before draining the oil.

Do oil drain plugs wear out?

Bolts and

threads don't fail over time

, unless they are cross-threaded or over-torqued – as you said. A 1957 Chevy with the original engine shouldn't have a stripped oil pan.

How much does it cost to replace an oil drain plug?

The general range is

between $100 and $350

, but there are some vehicles that cost more. You can get an oil pan gasket replacement for between $40 and $150. The part is not the most expensive part of the repair, but the labor can be very intensive.

Why is my oil plug leaking?

There can be several reasons why your drain plug is leaking. … If the washer is missing or deformed or if the gasket has dried out or torn, then these may be responsible for the leak. It's also possible

that the plug was installed too tightly

, causing the threads to be damaged and oil to leak out past them.

Can you drive a car with a leaking oil pan?

You should not drive a car if the engine is leaking oil from the top or bottom

. … An oil leak can also cause the seals and rubber hoses to wear down prematurely, which means they may need to be replaced sooner than expected. Furthermore, you could lose all of your oil as a result of a leak.