Inner Wire Diameter: The diameter of the inner wire,
1.2mm & 1.5mm
commonly used for throttle and choke cables, and 2.0mm, 2.5mm, 3.0mm used on clutch and brake cables.
How are throttle cables measured?
The clutch cable and brake line can be measured similarly from their corresponding connection points. … When doing this, only
measure the length of the housing
; do not include the length of the free wire at each end. Subtract the length of your stock cable from the new measurement that you have made with the wire.
Are throttle cables universal?
In today’s modern vehicles, throttle cables are
obsolete
with the widespread use of drive-by-wire throttle pedal assemblies. … Our universal throttle cable offerings fit most any application or engine type and mounting location.
How long is a SSR 125 throttle cable?
36′′
Throttle Cable for 70cc 90 cc 110CC 125 cc Dirt Bikes Pit Bike SSR Coolster Roketa SDG NST X-Treme Baja.
How long should my throttle cable be?
Most motorcycle manufacturers recommend
about 2 to 3 millimeters of throttle free play
, but over time the cables will stretch and settle into their housings and you’ll end up with more slack.
Do new handlebars need new cables?
Exactly how much the handlebar can grow before you need to modify or replace the hoses, cables, and wiring leading to it varies with each bike. Some bikes may have enough slack available in those parts to reach an extra inch or two. By routing them differently, you may gain more slack.
Is throttle cable and accelerator cable the same?
Your car’s accelerator cable, also known as a throttle cable, is a braided metal wire that connects the gas pedal to the engine throttle plate.
What happens if throttle cable is too tight?
When there is excess slack or the cable is too tight, this can
cause intermittent delays in throttle response relative to pressing down on the accelerator pedal
. This can also result in the opposite effect as well, in that the excess slack can create a delayed throttle return response.
Do throttle cables stretch?
Sometimes a cable can become stretched over time
, which will not only delay the response of the throttle, but can also leave the cable more susceptible to breaking. Delayed response may also be indicative of the need to have the cable slack adjusted.
How do you adjust a boat throttle cable?
- Loosen the throttle cable adjuster jam-nut with the wrenches. Extend or contract the adjuster until the cable moves the throttle to the idle position.
- Push the control lever forward to the “Forward idle” position. …
- Pull the control lever back, through neutral, into the reverse idle position.
What is Teleflex Cable?
Teleflex. Flexible Cables are
used for transmission of low voltage signals
, while permanently connecting fixed parts of machine such as panel board to any apparatus or mobile units.
