While there are a variety of reasons your Chevrolet Silverado 1500 won’t start, the most common 3 are a
dead battery
, an alternator problem, or failed starter.
What would cause no power to starter?
A blown fuse in the starter circuit
could be the cause of a no-start problem. Broken or corroded wiring – Damaged or dirty wires to the battery or to the starter solenoid (or wires that are loose) can prevent sufficient power from reaching the starter. … Sometimes the starter itself is the problem.
Why does my truck start sometimes and not others?
If your vehicle won’t start, it’s usually caused by
a dying or dead battery, loose or corroded connection cables
, a bad alternator or an issue with the starter. It can be hard to determine if you’re dealing with a battery or an alternator problem.
Why is my starter not clicking?
If you don’t hear clicking when you start the engine,
the problem may be a dead battery
. If you hear clicking, but the engine doesn’t crank, the starter might not be getting enough electricity. Using your owner’s manual and a voltmeter, you should be able to test functionality.
How do you start a Chevy Silverado truck?
Remote Vehicle Start✦ Press and release the Lock button and then press and hold the button until the
turn signal lamps flash
to start the engine from outside the vehicle. After entering the vehicle, turn on the ignition. During a remote start, the engine will run for 10 minutes.
Do starters just stop working?
Sometimes a starter motor just stops working one day with no prior signs
. … Sometimes a worn-out or shorted starter may turn over slower than usual, even if the battery is fully charged or new. In some cars a starter motor may produce abnormal grinding or screeching noises when it’s going bad.
Why won’t my truck start but has power?
The cause of this problem is usually one of 3 things – a failed starter motor,
a bad connection between the battery and starter motor
, or a blown fuse (if present) in line between the starter and the battery.
What are the signs of a bad solenoid?
- Engine Doesn’t Crank or Start. …
- No Clicking Noise When Trying to Start the Engine. …
- Starter Spins Without Fully Engaging the Flywheel (Rare) …
- Engine Cranks Slowly (Rare) …
- Test the battery. …
- Check That Power is Getting to the Starter Solenoid.
Why won’t my car start but my radio works?
If the lights and/or the radio come on but the car does not start, you may also
have dirty or corroded battery terminals
. The terminals are what connect the electrical system to the battery. … If you can get the car started by jumping it, it’s a good bet that your battery was the problem.
Why won’t my engine start but lights work?
This is usually due to
battery failure
, poor connections, damaged battery terminals, or a dead battery. Another sign of your “car won’t start, but lights come on” issue is that you have to jiggle the key to start the car. This shows you have a bad ignition switch, and the solenoid is not being activated.
How do you tell if it’s your starter or ignition switch?
Test the Starter
It
is under the hood
, usually on the passenger side at the bottom of the motor next to the transmission. The ignition switch is a set of electrical contacts that activates the starter and usually is located on the steering column.
When I turn the key nothing happens no click?
If nothing happens when you turn the ignition key to the “Start” position, it means that
the starter motor doesn’t turn over the engine
. Most commonly this could be caused by a dead battery; read above How to check the battery. … The ignition switch could be bad – it’s a common problem.
Why does hitting a starter make it work?
OTOH, a starter with a bad armature segment responds
well to tapping or banging with a hammer
. The vibration from the tapping/hammering usually causes the armature to move to the next segment, allowing the engine to start.
How do you reset the anti theft system on a Chevy Silverado?
The anti-theft is now reset. In a chevy silverado, you will try to reset the anti-theft system by
turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes
. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.
Does Chevy install remote start?
The Chevrolet Remote Starter System can
be quickly and conveniently installed in any
Chevrolet car, truck, van, crossover, or SUV manufactured in 2004+ to give their owners the ability to start the car at a distance.
How do I know if my Chevy has remote start?
Look for
a remote-start button shaped like a curved arrow
(on the physical key fob, this will be right below the lock and unlock buttons). If you see one then you have remote start capabilities, and if not, visit a “Chevy dealer near me“ to get it today!
