- Get into the exit lane. Posted signs will tell you which one.
- Signal your intention to leave the expressway by using your turn signal.
- Slow down as soon as you are off the expressway. Check the posted safe speed for the exit ramp.
- Do not make last-minute turns into an exit.
When exiting an expressway you should quizlet?
What steps should you take when exiting an expressway?
At least 1/2 mile from exit signal and make lane change to position 3
when safe to do so. Move into deceleration lane and cancel your signal*Flash brake lights to warn drivers behind you. Keep a safe distance, monitor you front and rear zones.
When exiting an expressway you should slow down?
Avoid slowing down on the freeway itself. Wait until you are in the deceleration lane. Then slow
gradually until your speed matches the posted exit ramp speed
. If you miss the exit ramp, never turn around or back up.
When you get ready to leave an expressway you should you should begin to use your turn signal?
Put your turn signal on approximately 100 feet before you reach the intersection. When driving on the highway and indicating an exit, lane change, or overtake, start your indicator lights
approximately 900 feet before you make the
change.
What four steps should you follow when exiting an expressway?
What steps should you take when exiting an expressway? *
At least 1/2 mile from exit signal and make lane change to position 3
when safe to do so. *Flash brake lights to warn drivers behind you. Keep a safe distance, monitor you front and rear zones.
What should not be done on expressway?
- Stop on the Highway. Accidents and emergencies happen, but you should never stop your vehicle on a highway lane unless you absolutely have no choice. …
- Back Up. …
- Drive on the Shoulder. …
- Use the Median as a U-turn. …
- Exit Your Vehicle.
How fast should you be going when merging on an expressway?
Five to 10 mph slower than the speed of traffic
on the freeway.
What should you always do when passing on the expressway?
at least four seconds.
never stop until off the expressway. pull onto the shoulder or median. slow down and use emergency flashers
.
What is the safest speed to drive your car?
Typically, the prevailing speed is what traffic engineers use to determine what the official speed limit should be on any given road. Speed limits are set using the speed of which
85% of traffic flows
. Studies show that this 85th percentile is the safest speed level.
What 3 factors can contribute to traction loss?
- The material the road surface is made from. …
- The condition of the road. …
- The condition of your tires. …
- The weight of your vehicle. …
- The balance of your vehicle.
What is the 3/6 second rule?
The 3-6 second rule ensures the
proper “space cushion”
to keep you and other drivers safe. When driving on slippery roads, you should double your following distance to at least… 4 seconds. Stay to the right and only use the left lane for passing.
When preparing to turn you should?
As you prepare to turn, reduce speed and stay as far to the right as possible. Begin the turn in the lane nearest to the right-hand curb and end the turn in the lane nearest the right-hand curb.
Give turn signal
. Yield to pedestrians who may be crossing your path.
Are you supposed to signal when backing out?
As you drive through the lot, remember that parking can be stressful for everyone.
Use your turn signals in a timely manner and yield
to drivers backing out of a space who may not be able to see the roadway. If you can’t find a spot immediately, be patient.
What are the four safe driving strategies?
- Think safety first. …
- Be aware of your surroundings — pay attention. …
- Do not depend on other drivers. …
- Follow the 3- to 4-second rule. …
- Keep your speed down. …
- Have an escape route. …
- Separate risks. …
- Cut out distractions.
What are three parts to an expressway entrance?
Steps to Entering Expressway
Expressway entrances include three areas:
the entrance ramp, the acceleration lane, and the merge area
.
When entering an expressway from the entrance ramp you should?
After entering the entrance ramp,
you should move into the acceleration lane
. This is the lane that runs alongside the main roadway. In the acceleration lane, you can adjust your speed to the speed of the expressway traffic until it is safe for you to merge into traffic.
