In most cars it is
under the center console that is between the two front seats
, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min.
Where is my airbag module located?
The location of the airbag module differs from vehicle to vehicle, depending on the make and model of it. In some vehicles, it is located in the center console, kick panel, under the radio, or behind the steering wheel. Generally, though, it can be found
underneath the driver's seat or front passenger's seat
.
How much does it cost to replace airbag module?
The average cost for an airbag control module replacement comes
between $685 and $712
for most cars and locations. The labor costs for this procedure are estimated between $103 and $130, while the cost of the parts is more expensive at $582.
How do I know if my airbag module is bad?
Symptoms of a failing airbag sensor
You can easily tell if the sensor is functioning if the
airbag warning light on the dashboard is illuminating every time
you start the vehicle. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.
What module controls the airbags?
An SRS airbag module, also known as the airbag electronic crash unit, controls the airbag's deployment, stores crash data and exchanges information with the car's engine.
Can you reset airbag module?
All airbag control modules can be reset and reprogrammed
, with the exception of flood, fire or hardware damage.
Can you drive car without airbag module?
While a vehicle can still run without an airbag module, it is strongly recommended that
drivers do not operate the vehicle without it being installed
—unless an emergency situation arises and there is no other option. … Without airbags deploying, a driver and any passengers can face severe injury or even death.
How long does it take to replace airbag control module?
The repair work is expected to take
about 2 hours
to complete, depending on dealer schedules. While repair times can vary from 1 to 2 hours, wait times might be longer depending on dealer schedules.
When should I replace my airbag control module?
The Airbag Control Module is designed to operate for the lifetime of the vehicle. On many vehicles, however, the module must be replaced
if one or more airbags are deployed in a crash
.
Does airbag module need to be replaced?
If your airbags have deployed during an accident, your airbags will need to be replaced, and your airbag control module
will need to be replaced or reprogrammed
. … It is recommended that a licensed technician replace damaged or deployed airbags to ensure proper care for safety on the road.
How do you check airbag codes?
The airbag codes are double digit numbers. To read the codes,
count the number of times the light flashes, wait for the pause and count the flashes again
. For example, two flashes, a pause and four flashes mean that your airbag system's problem is a code 24.
What does a solid airbag light mean?
When this light comes on, it indicates
that a problem has been detected in the system
, and one or more airbags may not inflate in the event of a collision. While it's possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. …
Remove the terminal clamp and leave it disconnected for 5-10 seconds
to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
Can you swap airbag module?
Airbags are not repaired and not repacked
. The airbag control module however can be reset to clear crash history and then can be used again instead of purchasing a new airbag control module.
How do you remove an airbag control module?
- First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. …
- Disconnect the positive battery cable and wait 3 min.
- You are now safe to unplug the airbag control module harness wiring plugs.
What is restraint control module?
A restraints control module (RCM) for
a vehicle is provided including a memory device
. The memory device stores a deployment time of a deployment event. … One of several advantages of the present invention is that it provides an apparatus for indicating when an RCM has been on a vehicle that has been in a collision.
