Start the car and allow 20 minutes to pass for the sensor to refresh. The TPMS reset button is usually located
under the steering wheel
.
If you want to reset the sensor, start the car and let it run for 20 minutes. The tire pressure monitor reset button can be found
under the steering wheel
.
How do you turn off the TPMS light on a Hyundai Sonata?
To reset the tire pressure sensor on the Hyundai Sonata simply
hold the reset button down until the TPMS indicator light
in the instrument panel blinks slowly 3 three times.
How do I reset my Hyundai?
To reset the computer in a Hyundai vehicle,
open the hood and use a wrench of pliers to disconnect the positive cable from the battery
. Look for the fuse that says ECM on it and remove it. Keep this removed for at least three minutes to clear the vehicle's memory.
How do you reset the check engine light on a Hyundai Sonata?
There are different ways to reset the check engine light on the 2018 Hyundai Sonata but sometimes it will just go off by itseLFAfter driving for a while. Another way that You can reset the check engine light on the vehicle is
to unplug the battery, wait for about 20 minutes and then plug it back in
.
Why is my tire pressure light still on after filling tires Hyundai?
If your TPMS light remains on after inflating the tires to the proper pressure, try these steps:
Drive the car at 50 mph for about 10 minutes
. … Without starting the car, turn the key to the “On” position. Press the TPMS reset button and hold it until the light blinks three times, then release it.
What does TPMS mean on Hyundai Sonata?
So, what does TPMS mean? The letters in this acronym stand for
Tire Pressure Monitoring System
, a tool that allows you to check or monitor your tire pressure right from your dashboard. If there's a problem, your TPMS will light up or flash to show you that it's time for a checkup. Service Service Specials.
Why TPMS light on but tires are fine?
TPMS Light stays on all the time
This could either mean
air pressure in
one or more of your tires is low. If you have already checked and know that this isn't the case, then it could indicate that the TPMS sensor is not reading correctly.
How long do I have to drive my car to reset the computer?
Here's something you probably don't know: after clearing the car's computer you will need to drive for
about 50 to 100 miles
. As you drive your car the computer will monitor all the sensors and register the results. You can use GOFAR to constantly monitor your car diagnostics.
How long does it take for a car computer to reset?
The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take
up to 100 miles
for all of the computer monitors to completely reset.
Why is my check engine light on Hyundai Sonata?
If the check engine light in your Hyundai Sonata starts glaring, that means that the
problem needs immediate attention
and your Hyundai should be brought in quickly. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system.
Will check engine light reset itself?
A check engine light will shut itself off if the condition that caused it is remedied
. So, if your converter is marginal, and you did a lot of stop-and-go driving, which creates high demand for the converter, that may have turned on the check engine light.
What is the most common reason for check engine light?
Oxygen Sensor
A faulty oxygen sensor will return a
check engine
warning every time. In fact, it's one of the
most common reasons why
a
check engine light
comes on while you're driving your automobile.
