Press and hold down the top button on the garage door remote. Locate the “SRT” button on the back of the mounted garage door opener . Wait for the indicator light on the garage door opener to flash....
The one button just opens the garage door. The three button has one to lock the door (if compatible) and one for the light.
The “Learn” button on your garage door opener is located above the antenna wire that hangs from the motorhead , it may also be under a light cover. The “Learn” button will be either green, red/orange, purple or yellow.
You now need to make this in-car transmitter your personal transmitter. Go to the Learn Button on your garage door opener. The button is usually next to the area where the floppy antenna is connected to the motorhead . With Genie, it is most often behind the light lens, and an indicator light flashes red when pressed.
chicat2001 – You will find a button (smart/learn) just to the left of where all those white wires go . Press and hold it for 6 seconds. This will erase the memory in the opener and your remote should no longer work.
The learn button on your garage door has two primary functions: to either pair new accessories with the opener or completely clear the memory , including all past connections with accessories or remotes.
How do I get a replacement garage door opener?
You can always search for a replacement opener remote from your unit’s manufacturer . We recommend quality garage door opener brands like LiftMaster®, as they can equip you with a new remote to replace your old one.
If it says “Learn” or something similar next to it, you have a smart switch unit . If there is no learn button, examine the inside of the old remote by popping the back off of it. If there is a series of small switches, only big enough to be slid one way or another by the end of a pencil, you have a DIP switch unit.
How do you reset the code on a old Craftsman garage door opener?
- Open the garage door from the inside and stand in front of the wireless outdoor control panel.
- Enter the existing four-digit code and hold “#.”
- Enter a new four-digit code and press “Enter.” The new code works immediately.
How do I reset my old Sears garage door opener?
- Step 1: Locate the mounted garage door opener. ...
- Step 2: Locate the “Learn” button. ...
- Step 3: Press “Top” button on remote. ...
- Step 4: Press “SRT” button on garage door opener. ...
- Step 5: Keep both the buttons pressed. ...
- Step 6: Connect any additional remote controls.
How do you program a garage door opener without a remote?
You can’t program a garage door opener without a remote controller. But you can use your remote transmitter to reset the garage door opener buttons inside your car. Or you can use an electronic keypad to control the door without a remote. For keypads, press the arrow buttons and the program buttons simultaneously.
Resetting Newer Openers
To reset the system, you will need to locate the button on the motor that reads “Learn” or “Home .” In many cases, this button will be located on the same side as the device’s antenna and next to an LED.
