The low-side port , like the name suggests, is lower on the pipes towards the front of the engine. While the low-side port is intended for recharging Freon, the high-side port is used for maintaining an air conditioner's internal pressure.
Do you put Freon in the high or low side?
The freon is added on the LOW PRESSURE SIDE ONLY . The hose tool you bought is made so you can only hook to the low side as the high side and low side fittings are different sizes and shapes for SAFETY'S SAKE.
Where is the AC low side service port?
The low side service valve is located in the line that runs from the compressor through the evaporator (firewall) and up to the condensor on the low pressure (suction) side of the system .
Which one is the low pressure AC port?
The low side service port is usually located between the AC compressor and evaporator . The low side service port will have a black or blue plastic cap that needs to be removed.
Which AC line is the high side?
The high side, or discharge line, will be the line connected to the compressor from the bottom or lower position . It will not be wrapped in insulation and will be warm to the touch. This is where freon exits the compressor as a liquid.
Does AutoZone check Freon?
When it's time for an AC recharge, turn to AutoZone. We carry R134a refrigerant, PAG46 oil, AC stop leak, AC system cleaner, and more. AutoZone will test your car's parts for free.
How many cans of freon is 3 pounds?
3 Lbs would be 48oz......... 4 cans . The refrigerant is measured in weight, not fluid ounces.
What color is the low side of an AC system?
Red hose goes to the high pressure side, blue goes to the low pressure side and yellow hooks to Freon source, can, etc.
What should the high and low side pressures be?
The system should be about 25 to 30 psi on the low side and 200 to 250 psi on the high side . If the ambient temperature is higher or lower than normal (70 to 80°F) the pressures will go up or down accordingly.
Will AC leak without cap?
The cap doesn't do anything to prevent a refrigerant leak , but I wouldn't drive around without it as it does keep keep dust/grit/water out of the port which can cause other issues and complicate future service.
What pressure should my home AC be at?
Your desired suction pressure is 33-48 degrees or 58-80 psi depending on the indoor temperature. (Note: The hot or warm air from a hot house traveling across the evaporator coil will warm the refrigerant faster than normal causing a higher suction pressure.
What is the high pressure port for AC?
The high side service port is a fitting that provides access to the high pressure side of the AC system and the low side service port is a fitting that provides access to the low pressure side of the AC system.
Which AC line is cold?
Feel the Larger Copper Pipe on your AC Unit. The Copper Pipe (Suction Line) should be sweating and cold to the touch during a hot day. If it is not cold, your compressor could be off (bad capacitor/ hard start kit) or low on Refrigerant.
What is the high side AC port for?
The high-side charge port is a quick-connect fitting that provides access to the high-pressure side of the A/C system . Most A/C systems are evacuated and filled from the high-side charge port in the assembly plant.
