The Tuff Torq K46 is the most popular integrated hydrostatic transaxle (IHT) in the world...and for good reason. This power unit has all the features and performance of much larger and more expensive transaxles, all at a very affordable cost and in a small and purpose-focused design.
What is K46 hydrostatic integrated with transaxle?
The K46 is the technology platform for Tuff Torq's deep line of compact integrated hydrostatic transaxles . It is optimized for rear engine riders, lawn tractors and small front deck mowers. The centered input shaft, narrow body width and short length make this an ideal hydro for the most confined mounting areas.
What is transaxle lawn mower?
A transaxle is a case that contains both the transmission components, differential and the drive axles . We generally use transaxle and transmission interchangeably when talking about todays lawn tractors because all of them use one case to house the transmission, differential and axles.
What is a K46 transmission?
The K46 is the most popular integrated hydrostatic transaxle (IHT) in the world ...and for good reason. This power unit has all the features and performance of much larger and more expensive transaxles, all at a very affordable cost and in a small and purpose-focused design.
Does Husqvarna use Kawasaki engines?
Husqvarna Lawn Mowers Powered by Kawasaki
Powerful and compact, their ergonomic design solutions allow you to keep up the pace and stay efficient even during long shifts.
What transmission is in a John Deere x300?
| Transmission | Transmission Tuff Torq K46 | Type belt-driven hydrostatic | Gears infinite forward and reverse | Oil change sealed unit, owner service is not recommended |
|---|
Is the K46 transmission serviceable?
Normally the Residential IHT (K46), which is featured in many tractor & rider models, does not require any servicing for the life of the vehicle . However, if there is a desire to check or replace oil, it may be necessary to remove the transaxle from the vehicle to access the black cap located under the pulley and fan.
What transmission is in a John Deere l130?
| Transmission | Transmission: Tuff Torq K46 HD | Gears: infinite forward and reverse | Oil capacity: 2.4 qts 2.3 L | Oil change: sealed unit, service not recommended |
|---|
Is the K58 serviceable?
The X380's K58 is more robust, is filter serviceable and has 1′′ axles.
How can you tell if a transmission is Tuff Torq?
Product Identification:
Tuff Torq Corporation (TUFF TORQ®) barcode labels are the only method to truly identify a product . Tuff Torq will be implementing a new barcode system in 2019. To the right you'll find first a diagram for the old barcode and second the new barcode.
Who makes Tuff Torq?
Tuff Torq Corporation is part of the Yanmar Global family of companies and draws upon their decades of experience to develop the premium product lines to best support our customers.
Which is better CVT or hydrostatic transmission?
CVT transmissions provide great value and the same top-end speed as a hydrostatic lawn mower transmission , but they can jerk a bit when you're starting out or maneuvering at slow speeds.
What's the difference between transmission and transaxle?
In short, a transaxle performs both the gear-changing function of a transmission and the power-splitting ability of an axle differential in one integrated unit. A transmission performs the gear-changing function only, delivering power via a single output shaft at the back of the unit.
What is a transaxle on a zero turn mower?
It's a cross between the words transmission and axle . So what is a lawn mower transaxle? A mower trans-axle is a single mechanical assembly that combines the functions of transmission, differential, and axle. The word trans-axle describes both the type of transmission and the axle set up in a vehicle.
How much oil does a k46 transaxle hold?
Tuff Torq recommends using only using approved Tuff Tech drive fluid when servicing any of our transaxles. Only use the fill port (covered by the black cap) to refill unit. You will need approximately 2.2 liters of oil to properly refill the unit if completely empty.
Why does my riding lawn mower run slow?
Maintenance lapses become evident when the mower turns over slowly or begins to falter at start-up. The fault could be a dirty spark plug, air filter or carburetor, or it could be related to the quality of the gasoline used . Slow starting can also be the result of a failure to clean the blades.
What kind of oil goes in a hydrostatic transmission?
The fluid recommended for Hydro-Gear transmissions and pumps is a 20W-50 motor oil or 15W-50 synthetic motor oil . If the machine has oil reservoirs, they are mounted to the frame behind the seat, for easy access and oil level check accessibility.
Who makes engines for Husqvarna riding mowers?
Husqvarna uses Kohler engines in two of its walk-behind mowers, while Poulan and Toro both use Toro engines in walk-behind and riding mowers.
Who make Husqvarna engines?
What Brand Motor Does Husqvarna Use? Engine manufacturers such as Honda supply the engines for the Husqvarna brand mower and other lawn mower manufacturers. There is only one Honda engine in push mower and walk behind mower configurations.
Is Husqvarna made by MTD?
MTD's main competitors are Stihl, Ariens, Briggs & Stratton, John Deere and Husqvarna . Over the years, MTD acquired the Troy-Bilt, Bolens, Cub Cadet, Craftsman (owned by its minority partner), and Yard-Man brands and/or companies. MTD also private labels for other brands under the “247” model prefix.
Is 400 hours a lot for a lawn tractor?
As a rough rule of thumb, a single-cylinder mower with 500-750 hours would be considered a high miler , but that's not to say it's all worn out. A well-maintained mower will go on and on, as said earlier, my own ride-on mower has about 1000 hours and still pulls its weight around here.
How much does a John Deere x300 weight?
| Dimensions & Tires | Weight 501 lbs 227 kg | Front tire 15×6.00-6 | Rear tire 20×10.00-8 | Full dimensions and tires ... |
|---|
Is a Tuff Torq K66 serviceable?
The Tuff Torq Professional Series IHT's are, K62, K66, K72, K92. They are described as for use in Commercial applications and are designed for “Heavy Usage”, ie, “Ground Engagement” and “Serviceable” , they also have heavier 1′′ plus axles.
What grade of oil do you use Tuff Torq?
A good quality engine oil: SAE 30, 10w40, 20w50 CD or CE . It is recommended that the oil be changed at every service or once a year. A good quality engine oil: Mobil 1 5w50, 15w50, Shell Gemini, 10w40, 15w50, Helix Ultra. A special synthetic oil, which has a peerless par number of 730228.
How do you purge a Husqvarna transmission?
After the engine is running, move throttle control to slow position. With motion control levers in neutral (N) position, slowly disengage clutch/brake pedal. Step 4-Move motion control levers to full forward position and hold for five (5) seconds. Move levers to full reverse position and hold for five (5) seconds.
