NHTSA reports that Honda is recalling 81,000 2004 – 05 Accord sedans
because of an airbag sensor that was installed improperly
. … If owners see the airbag light go off, they should have their car serviced immediately. Under the recall, all owners will have the sensor wiring harness replaced.
Why is my airbag light on in my Honda Accord?
If your Honda airbag light remains on, it most likely means that
the Supplemental Restraint System (SRS) has detected a problem with the airbag system
. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.
How do you reset the airbag light on a Honda Accord?
- Straighten out a paperclip.
- Pull down on the fuse panel cover under the steering column with your fingers to remove it.
- Locate the small yellow plug in the fuse panel. …
- Unplug the power connector from the fuse panel.
Why is my airbag light on all of a sudden?
When this light is on, that means
your airbags are deactivated
. It means they will not deploy properly if you get into an accident. If your car’s battery has drained recently, it may have also depleted the backup battery that powers the airbags.
How do I reset my airbag light?
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Can I drive my car if the airbag light is on?
If the airbag light is on, it means
that the airbag will not be able to deploy in the event of an accident
. This is a dangerous proposition, and it means that you should avoid driving if at all possible in that vehicle.
How much does it cost to fix a airbag light?
Number 1 — Reset Airbag Light
This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be
up to about $600
.
Will disconnecting battery reset airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. …
Remove the terminal clamp and leave it disconnected for 5-10 seconds
to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on
. … When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
What does the airbag light look like?
The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with
a large circle (the airbag) in front of the person
. It will normally light up briefly each time you start your vehicle, and then go off.
How do I know if my airbag sensor is bad?
Symptoms of a failing airbag sensor
You can easily tell if the sensor is functioning
if the airbag warning light on the dashboard is illuminating every time you start the vehicle
. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.
How do I check my airbag light code?
To read the codes,
count the number of times the light flashes, wait for the pause and count the flashes again
. For example, two flashes, a pause and four flashes mean that your airbag system’s problem is a code 24. Code 12 means your battery voltage is low, while 13 means the airbag circuit is shorted or grounded.
Will removing fuse disable airbag?
Simply pulling the airbag fuse may not disable the airbags
. Many ACMs utilize an internal battery to ensure deployment even if the power is cut.
