If the amp fuse is blown
, that is probably the reason that you aren't getting any sound out of your car radio. In some cases, a broken wire or bad connection in the speaker wires where they pass through into a door can also cut off the sound altogether rather than just cutting off the sound to one speaker.
Why is there no sound coming from my car stereo?
Typically when a car stereo produces no sound it's usually caused by a shorted or grounded wire, defective speakers,
faulty head unit/fuses
, or setup is not yet complete with your radio unit.
How do I fix the sound on my radio?
- Determine whether the problem is external. …
- Check the car radio ground connection. …
- Unplug the radio antenna and check if the sound is still there. …
- Check if moving the antenna wire removes static. …
- Check if moving other wires removes the static. …
- Install a noise filter or replace the head unit.
Why did my radio sound stop working?
Common reasons for this to happen:
Blown Fuse
: One of the most common reasons for a car radio to stop working is a blown fuse. … Damaged Antenna or Tuner: If the car's CD player still works, but the radio itself doesn't, then the problem most likely lies with either the antenna or the tuner.
How do you know if your car radio is blown?
- Distorted sound, hissing, and fuzziness. …
- Telltale popping or rattling instead of music. …
- Lack of bass, treble, or mid-tones. …
- Lack of vibration from the speakers. …
- Checking speakers for impedance.
Why did my car suddenly stop working?
Engines usually stop suddenly only
if they suffer from a lack of fuel or sparks
. … A slower, spluttering halt, on the other hand, probably indicates fuel problems – ignition faults that cause similar poor running are unlikely to stop the engine in the short term.
How do I fix my speakers hissing sound?
If you hear a hissing sound,
turn down the gain on the amplifier and turn up the volume on the receiver
. Adjust these two settings to minimize the hiss. Make sure the patch cables between the amplifier and the receiver are not running near other power wires (including the wire providing power to the amplifier).
How do I reset my car radio?
To do this, You have to turn your ignition to the ON position. Turn on your radio and see if it displays CODE or LOC. If it does, turn off the radio.
Press and hold down the audio power button together with the SEEK button for
about 50-60 minutes.
How much is a fuse for a car radio?
Cars run on electricity as well as gas, and almost all of it runs through fuses. Learn where they are, how to spot a blown fuse, and how to replace them. It takes about five minutes, costs
about $1
, and it'll save you the hassle of a trip to the repair shop.
How much does it cost to fix a car radio?
How Much Does It Cost To Fix a Car Radio? A. Depending on what's wrong, as well as the newness of the vehicle and whether or not it has a basic radio or fancy-schmancy infotainment unit, fixing it can range
between $100-$1,000.
How can I test my car speakers without a radio?
Remove the wires from the audio system, and with them still attached to the speaker, attach them to a 9-volt battery. You may hear a popping
sound
coming from the speaker. This means the speaker is working. If there is no sound, that indicates the speaker is blown.
What would cause my car speakers to stop working?
When all of the speakers in a car audio system all stop working at once, the problem is usually
in the head unit, in the amp
, or in the wiring. In some cases, an issue with the wiring between the head unit and a single speaker can even cause all of the speakers in an entire car audio system to cut out at once.
What makes a speaker stop working?
Speakers are essentially large coils of wire, and when they “blow”, it's generally that the
coil is taking too much current and isn't being cooled enough
, and is damaged. If the speaker is completely destroyed, this may be that the wire in the coil is broken or shorted, so that it doesn't operate.
