Why Is My Whirlpool Dishwasher Door Not Closing?

by | Last updated on January 24, 2024

, , , ,

Check that there are

no items such as silverware stuck between the door seal on the door and the tub of the dishwasher

. This will cause the door to not shut or seal properly. Check both racks for items that may be stuck and protruding. Remove any item that is protruding outside the rack.

Why is my dishwasher door not closing?

A dishwasher door

will not close properly if the plastic tub misaligned or is not installed correctly

, or if the door latch has malfunctioned. You'll face the same problem if the top or bottom racks inside aren't set correctly or if the door striker is misaligned.

How do you adjust the hinges on a dishwasher?

  1. Open the door slightly to about a 15 degree angle from the tub.
  2. Lift the door and move it back onto both hinges.
  3. When the door properly seats into place, you will hear a loud click. The door should now open and close freely.
  4. If the door is not opening and closing smoothly, repeat these steps.

How do I adjust the door latch on my dishwasher?

  1. Open the dishwasher door and remove the Torx screws securing the inner door panel to the outer door panel with a Torx driver. …
  2. Lift the inner door panel enough that you can loosen the two securing bolts on the door latch with a wrench. …
  3. Carefully raise the dishwasher door to align the door latch with the strike plate.

How do I test my dishwasher door latch?

Simply

open the door, close the latch and select a cycle and depress the switch

. Note that if the test is successful, with the door open, the dishwasher will operate and water may spray out. Make sure to first remove all tools from inside the dishwasher. Do not reach inside the dishwasher during the test.

How do you tighten a dishwasher door?

If the door closes too quickly, decrease the

spring tension by moving the spring end toward the front of the dishwasher

. If the door falls open, increase the spring tension by moving the spring end toward the back of the dishwasher. Springs should be in the same notches on the left and right sides.

How do I adjust the tension on my Whirlpool dishwasher?

If the door closes too quickly, decrease the

spring tension by moving the spring end toward the front of the dishwasher

. If the door falls open, increase the spring tension by moving the spring end toward the back of the dishwasher. Springs should be in the same notches on the left and right sides.

Where is door latch on dishwasher?

It is

located on the door of your dishwasher

, and is mounted on the inner door panel. The door latch can break from material fatigue. If the door is often slammed or opened quickly, the latch may break prematurely. If the door won't open or the door switches won't activate, you will need to replace this part.

How much does it cost to fix a dishwasher latch?

Part Cost to Replace What It Does Filter $50 – $100 Clears out bits of food. Sprayer arm $75 – $100 Rinses and cleans the dishes. Water inlet valve $80 – $125 Fills unit with the right amount of hot water. Door latch

assembly


$150 – $250

Keeps the door closed.

What is a door strike on a dishwasher?

The door strike at the top of a KitchenAid dishwasher

opening catches the latch to hold the dishwasher door closed

. … In order to fix a damaged door strike on your dishwasher, you must replace it with a new one.

Why does my screen door not close all the way?

Screen doors

fail to close properly when their hinges become imbalanced as a result of your home shifting

or if the door frame has swelled or become loose. Swelling paint also can be a factor. … For older homes where the door is severely out of square, consult a professional about jacking up the house from underneath.

Why won't my dishwasher open all the way?

If the dishwasher is able to slide or move a little it could

cause the door hinge to bottom against the edge of the cabinet trim

and prevent the door from opening all the way. … Check the both hinges and hinge springs while opening the door to see what's stopping the door from opening all the way.

Why is my front door not closing?


Improperly aligned hinges

can prevent your door from staying shut. A door that does not stay shut is usually improperly aligned at the hinges or at the strike plate and latch. This can be caused by settling of the house, improper installation of the door, or damage caused by slamming or excessive use of the door.

Can I bypass dishwasher door switch?

No,

you can't bypass one door switch

, both have to be in use and working, or you will cause other damage.

Why does my dishwasher door feel heavy?

Your dishwasher likely has

a broken or disconnected door spring or door link causing the door

to be heavy and fall when opened. Your dishwasher uses two door springs and two door links, one spring and door link for each door hinge. … You can access the door springs by removing the lower toe panel and access panel.

Why is my Whirlpool washer stuck on sensing?

You

may unplug and plug in the washer and turn the power on

. Lift and close the lid about six times within 12 seconds to reset the unit. You can also reset your washer by checking your product manual. Start a new wash cycle and test the appliance.

How do I reset the lid lock on my Whirlpool washer?

If your lid lock light is flashing, you

can unplug your washer for 10 minutes and plug it back in to reset the washer and the flashing light

. You can also press and hold the ‘End of Cycle' button for 20 seconds to reset the washer and flashing lid lock light.

How do I know if my dishwasher pump is bad?

If your dishwasher has a timer, turn the timer dial to the drain portion of the cycle to run the drain pump. Listen for the drain pump running.

If the drain pump runs but doesn't pump water and the drain path is clear

, then the drain pump is likely bad.

How long should a Whirlpool dishwasher last?

BRAND EXPECTED LIFE SPAN Electrolux and Frigidaire 10 years+ Kenmore 10-13 years LG 10-15 years Maytag, KitchenAid and Whirlpool

10 years

What is the average life of a dishwasher?

How long should a dishwasher last?

About 10 years

, according to most of the 20-plus manufacturers we asked. CR members tell us they expect the same life span, on average, but that doesn't necessarily mean 10 trouble-free years.

David Martineau
Author
David Martineau
David is an interior designer and home improvement expert. With a degree in architecture, David has worked on various renovation projects and has written for several home and garden publications. David's expertise in decorating, renovation, and repair will help you create your dream home.