Open the hood to the Dodge Stratus and
locate the positive and negative jump post locations
. They'll be on the driver's side of the engine compartment and will have a red plastic cap and cover for the positive jump post and a black cap and cover for the negative jump post.
Where is the battery located on a 2004 Dodge Stratus?
The Dodge Stratus battery compartment is located
beneath the engine compartment in the left front fender next to the wheel well
. The remote terminals for the battery are accessible through the engine compartment for jump starting.
How do you jump a completely dead battery?
Turn off the ignition on both cars. First, clamp one
end of
the positive cable to the dead battery's positive clamp. Now have a helper connect the other end of that cable to the other battery's positive clamp. Next, connect the negative cable to the negative terminal on the good battery.
How do you properly jump start?
- Take out your jumper cables. …
- Place both vehicles in Park or Neutral and shut off the ignition in both cars. …
- Attach one of the red clips to the positive terminal of your battery. …
- Attach the other red clip to the positive terminal of the other car.
How do you jumpstart a car by yourself?
Jumper cables are known to cause sparks and can ignite these vapors, causing fires or even possibly an explosion. If not done correctly, you can cause some
serious injuries
to yourself and others. A car that is jumped in the rain can also pose harmful results.
When I try to jump my car it just clicks?
A rapid clicking noise when trying to start your car could mean there's something wrong within the electrical system. Perhaps your battery's dead, or your alternator, which charges the battery, isn't working correctly. … You may need to replace your alternator or battery.
Can battery be too dead to jump?
Can a car battery be too dead to jump start?
No, the battery cannot be too dead that it cannot be jump started
. … The instant battery failure is a sign of the bigger problem.
Which terminal do you jump first on?
The safest order to attach the jumper cables is as follows: Attach one red jumper cable clamp to
the positive terminal
on the dead battery. Attach the other end of the same cable, the second red jumper cable clamp, to the positive terminal on the working (live) car battery.
When jump starting a car which cable goes where?
The jump start cable must only be held by the insulated plastic handles. Important: The
red cable is always connected to the positive terminal
and the black cable to the negative terminal. First the clamp of the red cable is connected to the positive terminal of the assisting vehicle.
Which car do you start first when jumping a dead battery?
Remember, when connecting the positive cables to the batteries, you
should always start by connecting the dead battery first
. If you feed energy into the cables before they are connected to your battery, you can cause a safety hazard.
How do you start a dead car battery without jumping it?
Turn off the ignition on both cars. First,
clamp one end of the positive cable to the dead battery's positive clamp
. Now have a helper connect the other end of that cable to the other battery's positive clamp. Next, connect the negative cable to the negative terminal on the good battery.
Can you jump a car with just a battery?
It's important to remember you
should never attempt to jump
-start a car with a damaged battery, which can catch fire or even explode.
How do you tell if its your alternator or your battery?
If your engine won't turn over or takes far longer than usual, it's time to grab the jumper cables and attempt a jump-start. If your engine
starts
and stays running but won't start again later, it's likely a battery problem. If your vehicle immediately stalls, it's probably a bad alternator.
How do you tell if its your starter or your battery?
When you attempt to start the car, there is
a low whining sound
. If jump starting gets your engine started and running, but the car will not start again once you turn it off, the battery is probably the problem.
How long should you leave jumper cables on?
Wait
two minutes as you turn
on the engine. Wait an additional two minutes after turning on the dead one. You can let the car run for two more minutes if you remove the cable in the reverse order you put it on.
