You can either buy a new freehub body or if you’re lucky your local bike shop or bike recycling project may have a stash ! Your replacement freehub body needs to have the same interface as your old one (meaning the same spline pattern) so it can fit onto your old hub.
How do I change my freehub body?
Which way does a freehub unscrew?
Turn remover only 1 full revolution counter-clockwise . Loosen and remove skewer before continuing to remove freewheel. Continue to turn remover counter-clockwise until freewheel is unthreaded from hub.
How do I remove freehub without tool?
How do I remove a Mavic freehub?
If you haven’t already done it, the first step is to remove the cassette and rear skewer. Next, use a 5mm allen key in the right side (drive side) of the axle, and a 17mm wrench on the nut. Turn the 17mm nut counterclockwise. ...and you can remove the whole freehub.
How do I change the freehub on my bike?
How do you disassemble a Shimano freehub?
How do I get rid of freehub body DT Swiss?
How do I get rid of a giant freehub?
The freehub body can then be removed by unscrewing either a hollow bolt or unscrewing the freehub body if it is threaded directly into the hubshell (some are). If the hollow bolt is accessed from the left side (some are) you will also have to remove the LH hub bearing before you can reach in with the allen key.
How do you disassemble a freehub?
- Remove set screw from side of drive side locknut.
- Hold non-drive side cone with cone wrench. Loosen and remove drive side locknut.
- Pull freehub to remove. Use care not to loose small parts. Note orientation of pawls as you remove freehub.
When can I change my freehub?
Check the freehub for wear to see if it needs replacing or just cleaning and relubing. To do this, firmly grab the splined body and give it a wiggle. If it moves more than a couple of millimetres side to side, replace it .
How do I know what freehub I have?
How do I remove single speed free hub?
How do you remove a single rear sprocket from a bicycle?
How do you remove a cassette from a wheel?
How do I remove Mavic Cosmic freehub?
How do you disassemble a Mavic front hub?
How do you remove a Mavic Crossride freehub?
Just hold the axle with a 5mm allen key and undo the locknut and remove it. Then just turn the freehub anti-clockwise and it should pull off the axle easy . Clean everything up, put a dab of light grease and lube on the pawl seats, 10 or so drops of lube on the freehub ratchets and bung it all back together.
