The Weller WP35 soldering iron happens to be the most power-efficient soldering iron stated in this listicle. Even at a low power consumption, this soldering iron can go up to 850 degrees Fahrenheit. While it may not be the highest, it is quite respectable when you consider the given wattage of just 35 watts .
How do you replace a Weller tip?
What is a Weller Portasol?
Piezo ignition with push-button ease & convenience . Portasol® is a registered trademark of Olgesby and Butler Limited. Gas capacity allows up to 1 hour of continuous use, ample for most jobs.
Why is my soldering iron not hot enough?
The majority of soldering irons run on electricity and, if the circuit is broken, the electricity will no longer work. If your soldering iron isn’t producing any heat, it is likely because of a break in the electrical circuit, resulting from either a faulty connection in the iron or heating element failure .
How do you light a Portasol soldering iron?
What happened to Ungar soldering iron company?
New Old Stock. Ungar was purchased by Weller, swallowed by Cooper and than Apex Industries . Ungar – 7760 – Soldering equipment. Soldering iron handle, 2 wire.
Are Weller and Hakko tips interchangeable?
The two tips are the same geometry, hollow cylinder . The Weller tip has an outside diameter of about 0.247 inches. The Hakko had OD 0.268 inches, and thus doesn’t quite slip into the Weller “socket”.
How hot does a Weller soldering iron get?
Capable of producing temperatures up to 900°F to handle many soldering projects. The station includes a Weller certified ST3 iron-plated copper tip to help keep the temperature consistent while making soldering joints.
How do you refill a Portasol?
How do you use Weller gas soldering iron?
Hold the hot iron to the place where the two metal components will meet for about a second to heat them up. You want to heat the metal parts, not the solder itself. Then, touch the solder to the heated components. As the solder melts, it will flow into the gaps it needs to fill.
How do you use a Weller butane torch?
How do you restore a soldering iron tip?
- Adjust the temperature of the soldering iron to a typical work range (about 300°C).
- Apply flux-cored solder to the oxidized tip. ...
- Use brass wool or specially designed cleaners on the tip. ...
- Repeat the steps above until the tip is clean.
When should I replace my soldering iron tip?
Tinning Your Tips
You should tin your tips before and after each soldering session, as well as in between soldering every two to three joints . You want to keep your tip tinned at all times, from the first time you use it until you discard it.
How do you replace a soldering gun tip?
Why is my solder not sticking to my wire?
If you let the solder sit on the iron, the flux quickly boils off (the fumes are from flux, not the lead). And without flux, soldering becomes almost impossible. Flux removes oxidation from metals, and it’s crucial because solder won’t stick to oxidized metals , and metals oxidize very quickly at soldering temperatures.
Why is my soldering not sticking?
A classic reason solder won’t stick to something is because you’re not getting it hot enough . My interns come to me with this problem all the time. Make sure the tip of the iron is nice and shiny. Touch some solder on it, and it should melt almost instantly.
How long does it take for a Weller soldering iron to heat up?
My (also 25 W) says that 1 minute is needed to reach operating temperature. The heat transfer also depends a lot on the condition of the tip. If the tip is bad, then it could take a while for it to melt solder even if the temperature is reached.
What soldering stations use Hakko tips?
Soldering Iron Tip for the standard irons supplied with the Hakko FX-888D, FX-889, FR-701 and FR-702 Soldering Stations.
