A 1999 Dodge Ram 1500 with a 46RE transmission requires 4–5.5 quarts of transmission fluid — 4 quarts for a drain-and-fill with filter change, up to 5.5 quarts if dropping the pan and cooler lines.
What kind of transmission fluid does a 1999 Dodge Ram 1500 take?
Stick with Valvoline Synthetic ATF+4 or any Chrysler-approved ATF+4 fluid. Grab a single 1-quart bottle for a simple drain-and-fill, but pick up a 6-quart jug if you're dropping the pan and flushing the cooler.
Chrysler’s 1999 service manual pushes Mopar ATF+4 (MS-9602) or anything that meets the spec. Valvoline, Pennzoil, and Red Line all sell ATF+4 synthetics that check the box. Just make sure the bottle says “ATF+4” — earlier fluids like ATF+2 or Dexron III won’t play nice with these trucks.
How many quarts of oil does a 99 Dodge Ram 1500 take?
With a fresh filter, the 5.9L V8 holds 5 quarts of 5W-30 or 10W-30 oil. Warm the engine, shut it off, wait two minutes, then check the dipstick.
The 5.2L Magnum V8 uses the same 5-quart capacity. Always match the oil weight to your climate — 5W-30 flows better when it’s cold, while 10W-30 holds up better in heat. Don’t skip the dipstick check after refilling; top off to the “Full” mark.
How much transmission fluid does a 99?
A 1999 Dodge Ram 1500 with the 46RE transmission holds 4 quarts when you change the filter and 5.5 quarts if you drop the pan and cooler lines.
That extra quart or so stays trapped in the torque converter and cooler lines. If you’re just draining the pan and leaving the converter full, four quarts should do it. For a full flush, grab five or six quarts so you can refill to the correct hot-level mark. Always check the level with the transmission at operating temperature and the truck in Park on a level surface.
How many quarts of transmission fluid does a 95 Dodge Ram 1500 take?
A 1995 Dodge Ram 1500 with a 46RH/46RE transmission takes 5.5 quarts during a complete service.
That covers a drained torque converter and cooler line flush. If you’re just doing a drain-and-fill with a filter change, plan on about four quarts. When in doubt, check the transmission dipstick chart in the service manual for the exact capacity.
How many quarts of oil does a 5.9 L Dodge Ram take?
Both the 5.9L Magnum V8s in the 1999–2002 Rams need 5 quarts of oil with a new filter.
The 5.2L Magnum uses the same 5-quart capacity. Stick to the oil weight in your owner’s manual — 5W-30 for cold weather, 10W-30 for hotter climates. After draining, slap in a new Mopar or high-quality aftermarket filter (part # MO-090 or equivalent) before refilling.
What type of oil does a 5.2 Magnum take?
The 5.2L Magnum V8 calls for 5W-30 below 32 °F or 10W-30 above 32 °F; synthetic blends or full synthetic are your best bet.
Chrysler’s 1999 service info lists SF/SG/SH quality oil that fits those viscosity ranges. Valvoline, Pennzoil, and Mobil 1 all sell API-licensed oils that meet or beat those specs. Change the oil and filter every 5,000 miles under normal driving, or every 3,000 miles if you’re hard on the truck.
How many quarts does a 46re transmission take?
The 46RE transmission holds 4 quarts for a drain-and-fill with filter change.
Drop the pan and flush the cooler lines? You might need up to 5.5 quarts. Always double-check the dipstick after refilling — add fluid in ½-quart increments until the level sits between the “Add” and “Full” marks. Overfill, and you’ll get foaming and lousy shifts.
What kind of transmission fluid does a 1999 Ford Ranger take?
A 1999 Ford Ranger with the 4R44E/4R55E transmission requires Dexron III (G) or Mercon V automatic transmission fluid.
Ford calls for Mercon V in 1999–2001 Rangers, but Dexron III (G) works too. Use Motorcraft, Valvoline, or Red Line — just make sure it’s the right stuff. Always check the transmission fluid temperature with a scan tool or follow the dipstick procedure; fluid should be between 160 °F and 200 °F for an accurate reading.
How much transmission fluid does a 47RE hold?
The 47RE holds roughly 4 quarts for a drain-and-fill service and up to 5 quarts for a full flush including the torque converter and cooler lines.
Grab a 5-quart jug so you don’t run dry mid-refill. After topping off, run the transmission through all gears with the engine idling, then recheck the level at operating temperature. Adjust to the correct mark on the dipstick to avoid over- or under-filling.
What kind of transmission fluid does a 98 Dodge Ram take?
A 1998 Dodge Ram 1500 with the 46RE transmission uses Valvoline Synthetic ATF+4 or any Chrysler-approved ATF+4 fluid.
Mopar ATF+4 (MS-9602) is the factory recommendation, but Pennzoil Platinum ATF+4 and Red Line Synthetic ATF+4 also meet the spec. Always confirm the label says “ATF+4” — using older fluids like ATF+2 or Dexron III can wreck your transmission’s shifting and cause internal wear.
How many quarts of oil does a 96 Dodge Ram 1500 take?
The 1996 Dodge Ram 1500 with a 5.2L or 5.9L V8 takes 5 quarts of oil with a new filter.
After draining the old oil, swap in a new filter (Mopar MO-090 or equivalent) and refill with the right viscosity — 5W-30 for cold weather or 10W-30 for warmer climates. Check the dipstick after refilling and top off to the “Full” mark to keep your engine happy.
How much oil does a 98 Dodge Ram 1500 take?
A 1998 Dodge Ram 1500 with a 5.2L or 5.9L V8 holds 5 quarts of oil with a new filter.
Pick the oil weight for your climate — 5W-30 in cold conditions or 10W-30 in hotter temps. Warm the engine to operating temperature, shut it off, wait two minutes, then check the dipstick. Top off as needed to the “Full” mark so your engine keeps running smoothly.
How much oil does a 7.3 take?
The 7.3L Power Stroke diesel holds 15 quarts of oil with a new filter.
That’s the same no matter the model year or build date. Use a high-quality 15W-40 CJ-4 or CK-4 diesel oil and a fresh OEM or premium aftermarket filter (Motorcraft FL-1995 or equivalent). After refilling, run the engine for 30 seconds, shut it off, and recheck the dipstick to make sure the level is between the “Add” and “Full” marks.
What kind of transmission fluid do I need for a 2001 Dodge Ram 1500?
A 2001 Dodge Ram 1500 with the 46RE transmission requires synthetic ATF+4 fluid. The complete service capacity is 5 quarts.
Mopar ATF+4 (MS-9602) is the OEM fluid, but Valvoline, Pennzoil, and Red Line synthetic ATF+4 fluids are also approved. Always confirm the label says “ATF+4” — older fluids like ATF+2 or Dexron III can cause shifting issues or internal damage in these trucks.
What kind of transmission fluid does a 1999 Ford Ranger take?
A 1999 Ford Ranger requires Dexron III (G) or Mercon V Automatic Transmission Fluid.
Ford specifies Mercon V for 1999–2001 Rangers, and Dexron III (G) is backward-compatible. Stick with reputable brands like Motorcraft, Valvoline, or Red Line. Always verify the fluid temperature via scan tool or dipstick procedure — it should sit between 160 °F and 200 °F for an accurate reading.
How much transmission fluid does a 47RE hold?
The 47RE holds right around 4 quarts, so grab 5 just to be safe.
That covers a drain-and-fill service. If you’re doing a full flush, including the torque converter and cooler lines, you’ll likely need the extra quart. After refilling, run the transmission through all gears with the engine idling, then recheck the level at operating temperature. Adjust to the correct mark on the dipstick to avoid over- or under-filling.
