Proper use of diagonal cutting pliers: For
work involving cutting and skinning wires, cutting and removing pins, nails and other fasteners
.
What can you cut with diagonal cutters?
Unlike scissors, which cut by shearing, diagonal cutters work by indenting and wedging the line. This particular tool is used for
cutting cables
. It can handle soft metals like copper, brass, aluminum, iron, and steel.
Can you cut nails with diagonal pliers?
Diagonal cutting pliers are used for
cutting wires
, screws and nails. … They are small hand tools originally designed for electricians to cut small wires but they are so useful they can be found in almost every toolbox.
What do diagonal pliers have?
Diagonal pliers have
a pair of jaws, a fulcrum point, and a pair of handles that are often dipped in colored plastic
which serves as an insulator. Diagonal pliers are a type of pliers used to cut wire. They are specially designed to accomplish a cutting, rather than gripping or pulling, task.
Are diagonal pliers the same as wire cutters?
Diagonal pliers (or wire cutters or diagonal cutting pliers or diagonal cutters) are
pliers intended for the cutting of wire
(they are generally not used to grab or turn anything).
When would you use a diagonal cutter?
Diagonal cutting pliers are used for
cutting wire and small pins in areas that cannot be reached by larger cutting tools
. Because the cutting edges are diagonally offset about 15 degrees, these can cut objects flush with a surface.
What is a diagonal cut?
Diagonal Cut. When diagonal cutting,
the knife enters at a 45 ° angle
. … The cutting motion is a smooth, backward draw of a very sharp knife followed by a roll of the wrist to prevent slices from sticking together.
How does diagonal cutting pliers work?
Diagonal cutting pliers use
lever action to create enough force to cut through small pieces of metal
. The force applied by your hand as you squeeze the handles together is magnified through the pivot point and causes the jaws to move together.
Who uses diagonal pliers?
More commonly used by
engineers and mechanics for hard wire cutting
(e.g. welding wire), manufacturers of sprung bed mattresses, piano technicians and electricians. Shop the Maun Diagonal Cutting Plier For Hard Wire 160 mm. Both are available in classic finish.
What are the types of pliers?
Pliers are used to grip, position, tighten, loosen, and cut certain metal elements. Learn about five types of pliers:
slip-joint, water-pump, linesman, locking and needle-nose
.
Do pliers cut metal?
There are a number of pliers that are designed with a
cutting blade
that will allow you to cut metal or wire, including the standard model pliers. The cutting edge of the pliers is normally located in the back of the jaws and has a serated or sharpened edge, allowing you to cut the metal without too much trouble.
Who make the best side cutters?
- Knipex Diagonal Cutters.
- Irwin Diagonal Cutters.
- Klein Tools Diagonal Cutters.
- Crescent Diagonal Cutters.
- Craftsman Diagonal Cutters.
- Wiha Insulated Diagonal Cutters.
What is the importance of pliers?
Pliers are
a hand tool used to hold objects firmly
, possibly developed from tongs used to handle hot metal in Bronze Age Europe. They are also useful for bending and compressing a wide range of materials.
What is a side cutter tool?
Side cutters are
used to cut wire and the leads (or legs) of components in electronics
. They can also be used to strip the insulation from wire. The video below shows small electronic side cutters being used to strip the insulation from the wires of a battery clip.
What is a flush cutter?
Flush-cutters –
provide an unbroken, even cut to the material for a clean design look
. … Because the jaws are angled, both ends of the wire cannot be cut flush, only the wire on the side that is flat will be flush, the wire remnant on the angle side will have an angle or “V” cut.
