For most exterior boards – especially HardiePlank and other fiber cement materials – the best way to nail is corner to corner “blind nailing.” Blind nailing refers to nailing each board, one at a time, and then overlapping that nailed layer with the next board, so that all nails are hidden.
What is a blind nail used for?
The Blind Nail allows you to have an invisible mechanical connector . Simply insert the dual head nail into the set tool to set the nail, then tap the molding or wood into place on the other side. The Kit includes the Blind Nail Tool and Blind Nails.
What is a blind nailer?
If you’ve never heard the term blind nailing, you’re probably wondering what exactly it means. Blind nailing is setting a nail into the hardwood flooring board at a 45 degree angle, just above the tongue of the board and driven down into the joist or subfloor surface .
What is face nailing?
: nailing in which the nailheads are exposed to view and which is used in the fastening of facing wood to a base.
Should you see nails in siding?
Most contractors agree that nails used in siding projects should measure at least 1 1⁄2 inches long —or up to 2 1⁄2 inches if you’re installing backerboard with the siding.
What kind of nails do you use for tongue and groove?
The two most common types of nails used for tongue and groove paneling projects are the brad nail or the finish nail . Brad nails are made of 18-gauge steel wire and because they are very thin nails, it makes them perfect for use with delicate material such as pine wood.
How do you attach tongue and groove?
Secure the first row by nailing into the tongue to the joist, (or furring strip) and secure the groove side of the plank by face nailing into the joist. Insert the nails into the tongue at an angle and use enough force to have the nail flush with the surface of the tongue.
Can you use a brad nailer for tongue and groove?
A finish nailer or brad nailer is the easiest and most efficient tool to use when installing your new shiplap or tongue and groove. ... If your nailer has a depth setting, you should dial it to shoot the nail 1/16” below the face of the board.
Is it OK to face nail Hardie siding?
Face nailing is applicable where dictated by building code , in high wind areas, and when fastening is to OSB or equivalent sheathing without penetrating into studs. ... Fasteners shall be installed between 3/4 in. and 1 in. from the bottom edge of the board and the head must be snug, not counter sunk or overdriven.
Is toe nailing strong?
Toenailing not only makes a strong joint but also is a great way to coax stubborn boards into position. Photos 1 – 3 walk you through the basic steps of toenailing. The key to success is starting the nail in the right spot and angling it a little steeper than 45 degrees.
What does toenail mean in carpentry?
Toenailing — driving a nail at an angle — is a method often used to fasten wall studs to the sole plate, as illustrated. If you have trouble keeping the stud in position while nailing, lay a 2×4 spacer block behind it.
What size nails do you use for siding?
Nail Length
Ideally, you should space the nails so that each one penetrates a stud; 8d nails , which are 2 1/2-inches long, are suitable for most siding materials. It isn’t always possible to nail into studs, especially when you’re installing shake siding.
Can I put a nail in siding?
To make your home more beautiful or to celebrate different holidays or seasons, you may want to hang decorations on the side of your house. This can be tricky with a vinyl-sided house because you shouldn’ t drill or nail through the siding. Holes can cause water to seep behind the vinyl, creating problems for your home.
