The faucets themselves run from about $150 to well over $1,000. However, a basic, simply designed model should be more than adequate and cost around
$250
. The installation including materials, should run about $75 for a remodel or around $310 for an existing kitchen, depending upon the complexity of the project.
Is a pot filler worth it?
The bottom line
Pot fillers can be a
very useful tool
in your kitchen as long as you do a little homework beforehand. They’ll make it much quicker and easier to fill your pots while cooking.
Is it easy to install a pot filler?
1. Pot Fillers
Require an Involved Installation
. If you already have a pot filler installed, you do not need to worry too much about the installation process since you will only need to replace the old one with a new model. However, if you do not have one, you may be surprised by the installation process.
What is a pot filler used for?
When
renovating or upgrading your kitchen
, one option you will come across is a pot filler faucet. Also known as a kettle faucet or pasta arm, this single-temperature faucet (usually cold water) is designed so you can fill pots of water directly on the stove rather than in the sink.
How long should a pot filler be?
A double-jointed pot filler should be
about 20 to 25 inches above the burners
, according to Rapid First Plumbing. The reach of the extended pot filler should be 22 inches to cover the front and back burners. The valve should be to the left or right of center, writes Waterstone Faucets.
Do you run hot or cold water to a pot filler?
Pot Fillers
You
can run either a hot water line or a cold one
, they don’t have a mixer and therefore can only dispense the water they are hooked to. They can be installed on the wall or on your countertop.
Where do you place a pot filler?
The pot filler should be placed
to the right or left of the cooking surface
to avoid reaching over the cooking surface to access. The pot filler can be placed above the cooking surface. However, it can get hot from the surface burners or a large pot.
How high should a pot filler be from the floor?
Though, that begs the question, how high should a pot filler be from the floor? If you would like to know, let’s find out. Pot fillers are typically located on a wall over a stovetop. If you want to avoid problems, you should mount the pot filler at
12 to 24 inches above the stove burner
.
Can you install a pot filler upside down?
No.
There’s no way that will work
with this one, unless you’re looking to make a fountain.
Can you put a pot filler on an outside wall?
It should be OK “IF”
you keep the supply near
the inside of the wall “AND” if you are successful in getting the insulation contractor to only put insulation between the outside and the supply with nothing between the inside and the supply.
How do I choose a pot filler?
Here’s What You Need to Think About:
Check the
reach in the faucet specs
to make sure the model you are considering can get to every burner. Double jointed pot fillers have a longer reach—20′′ or more to a typical 15′′ reach for the single jointed models–so they work better for large cooktops.
How does pot filler work?
Pot Filler Faucets have an
articulated arm that enables the tap swing out over the burners so you
can fill large stock pots where they will be heated. Proponents say the biggest positive is reducing strain on your arms, back, and hands from lugging heavy, water-filled pots from the sink to the stove.
Why do pot fillers have two valves?
When looking at pot filler faucets, consider ones that have two separate on and off valves. You may think this is poor design until such time as you walk away from your pot filler and it has a slow drip. The second valve
acts as a safety to minimize damage that might be
caused by a dripping faucet.
