Ford Focus CV Axle / Shaft Assembly Replacement costs
$330 on average
.
How much should a CV joint replacement cost?
A CV joint itself can cost between $95 and $210. Hiring a mechanic to perform a replacement
will be between $165 and $800
. The price mainly depends on whether you’re replacing a double or single axle.
Is it OK to drive with a bad CV joint?
In a front-wheel drive car, the axles are connected to the wheels with Constant Velocity (CV) joints. … A severely worn out CV joint can even disintegrate while you’re driving and make the car undrivable. You may lose control of the vehicle entirely.
It is not safe to drive with a damaged CV joint.
Is replacing a CV joint expensive?
A CV joint itself can cost
between $95 and $210
. … The constant-velocity joint replacement cost of a double axle will be approximately twice as expensive as a single axle, with the parts cost for a double running between $150 and $400.
How much is a CV axle for a Ford Focus?
Car Service Shop/Dealer Price | 2018 Ford FocusL4-2.3L Turbo Service typeAxle / CV Shaft Assembly – Driver Side Rear Replacement Shop/Dealer Price $831.40 – $1183.97 | 2012 Ford FocusL4-2.0L Service typeAxle / CV Shaft Assembly – Passenger Side Rear Replacement Shop/Dealer Price$697.82 – $1028.82 |
---|
How hard is it to replace a CV joint?
replacing
both sides shouldn’t take any more than 4 hours
. have your manual with you, you’d probably need to undo the cv lock nut, separate complete hub assembly from the strut, pull the cv out.
What happens if a CV joint breaks while driving?
If a CV joint begins to fail while driving, your car will start to pull to one side as one wheel loses power. When the joint breaks
completely its corresponding wheel will no longer turn
and although the engine may still run, the car won’t move. … If possible, slowly steer your car off the road and then call a tow truck.
How long does it take to replace CV joints?
On the 2006 Navigator, if a professional mechanic is replacing the axle(s), it is assumed to take
about 1 hour
to replace one axle (i.e., one side) whether it is the rear axle or the front axle.
How long can you drive on a bad CV joint?
Let’s get down to the answer. The answer will be relative from one CV axle to another. It could take weeks, months, or years. But the average lifespan of a bad CV axle is
around five to six months
.
What are the signs of a CV joint going bad?
- 1) Vibrations. If there is a damaged or worn CV joint, then it will start to vibrate as the vehicle is in motion. …
- 2) Grease on Wheel or Tire. If your vehicle has a boot that is torn, it could result in grease leaking from it. …
- 3) Knocking Noises. …
- 4) Loud Turning Sounds. …
- 5) Bouncy Ride.
How much is a front axle replacement?
The cost to repair an axle runs
between about $500 and $600 dollars
before taxes and fees. Costs vary depending the type of vehicle, brand, make, and model. Labor costs vary from between about $50 dollars and $140 depending on how long the job takes for a model of vehicle.
How much is a CV shaft?
Replacement axle shafts can be bought for
between $60-150.00 each
, and labor is generally between 1.5-3 hours to replace, bringing labor to around $150-350.00.
How much does it cost to replace CV joints UK?
A CV joint itself can cost between $95 and $210. Hiring a mechanic to perform a replacement
will be between $165 and $800
. The price mainly depends on whether you’re replacing a double or single axle.
Can a bad CV axle mess up your transmission?
In short –
yes
. If the CV axle was removed from the transmission while driving, it is more likely than not that internal components were damaged. However, the only way to know for certain is to contact a professional mechanic who can inspect your Pontiac’s transmission and gears for additional damage.
How do you test a worn CV joint?
- Put the car in reverse. Then turn the steering wheel all the way to one side and drive backward in a circle. Turn the steering wheel in the other direction and repeat the process.
- If you hear a very pronounced clicking or snapping noise, there’s a good chance an outer CV joint is worn out.
Do you need an alignment after replacing CV joints?
Yes
. Anytime you disassemble and reassemble any parts of the suspension or connected components, you will need an alignment afterwards.