If you decide to remove the carpet, you must also pry up the tack strips, which are held in place with nails. If the floor is made of concrete, you are left with unsightly holes along the perimeter of the room. You can repair these holes by
filling them in with a patching compound
.
What do you use to fill nail holes in concrete?
If you can’t find premixed concrete patch, you can make your own by mixing
one part cement to 2.5 parts fine sand
. To fill holes deeper then 1/4 inch, apply at least two layers of the cement patch. To make sure the patch sets properly, cover it with plastic sheeting for about five days.
How do you remove tack strips without damaging concrete?
How do you fix a small hole in a concrete floor?
- Step 1: Use a hammer and a cold chisel to level the bottom of the hole. …
- Step 2: Brush on a concrete bonding liquid. …
- Step 3: While the bonding agent is still tacky, mix the concrete. …
- Step 4: Level the patch.
Do I have to patch tack strip holes in concrete?
How do I fill a hole in a concrete slab?
- Undercut the Hole’s Edges. Put on safety glasses. …
- Vacuum Up Debris. …
- Add Sand to the Hole. …
- Use a Concrete Bonding Liquid. …
- Mix the Concrete. …
- Remove Excess Concrete. …
- Wait for the Concrete to Cure. …
- Trowel the Surface.
Can you use grout to fill a hole in concrete?
Grout is a kind of concrete, after all. But grout is filling only small holes that do not affect the structural performance of the concrete.
As long as it sticks and you are able to hone it off in a reasonable amount of time, it’s fine
.
How do you fill in holes in concrete before painting?
How do you remove nail strips from concrete?
Pry up the nail. If it sticks in the concrete, hit the heel of the pry bar hard with the hammer. This should pop the nail free. Pull the tack strip up and back with your hands until the next nail stops you.
How do you remove nails from a concrete floor without damaging it?
Can you glue down carpet tack strips?
How do you remove carpet tack strips?
Can tack strips be reused?
Nope! Please leave the old tack strips in place.
We should be able to reuse them
. If there are any that are in bad shape we will pull them up and replace them when we arrive.
Should I fill tack strip holes before laying laminate flooring?
3 Answers. Show activity on this post.
You don’t need to fill pits of that size
. The laminate floor will easily span that no problem.
How do you fill pin holes?
Can you use Portland cement to fill cracks?
Fill the Crack with Patching Mix (also know as Vinyl Concrete)
Patching mix is made from vinyl, Portland cement and sand
. It covers cracks up to 1⁄2 inch wide. Dampen the area around the crack, and then trowel on the mix.
Can polyfilla be used as grout?
Polyfilla® Wall Tile Grout is a specially formulated water and stain repellent, ready to use grouting compound for ceramic wall tiles.
It is recommended for both new ceramic tiling and re-grouting applications
.
What kind of primer should I use on concrete?
Acrylic/Latex: Because concrete is porous, a
water-based or acrylic primer
is more likely to soak into the concrete than an oil-based primer, bonding to the substrate and allowing the paint to grip the surface. These primers will also reduce the dust on interior concrete.